|
|
2005 Chrysler 300 3.5L Misfire
This vehicle runs well when warm, but when it's cold, and
RPM's are around 2000, it feels like it misfires badly. If
you give it more throttle, the trans downshifts, and the
problem goes away when the RPM's go up. However, NO CODES
ARE STORED FOR MISFIRE. Fuel... |
View |
|
2005 Chrysler Pacifica 3.5L MIL Lamp on
have codes p0440 evap general failure and p0456 evap small
leak. i checked the system visually, ok but dont have smoke
machine. cleared codes and ran evap monitor test with
scanner and po440 came back. please help looking for common
failures due to no smoke ma... |
View |
|
1989 Dodge Pickup 5.9L No Start
Thanks for your help in advance. I do not have much diesel
experience and not much service info. This engine will not
start when cold. When I say cold, I mean in 30's. People
don't know what real cold is around here so I am not
talking like -4 or something. Ch... |
View |
|
1997 Dodge Pickup 5.2L Surge, Stall, starts then dies
hey guys,
we have just installed a new engine in this thing as the
old one had lost compression. we are at our wits end. this
engine cranks long then fires up and dies. then may do it
again but most of the time cranks even longer after first
fire.
TDC HAS BE... |
View |
|
2000 Dodge Grand Caravan 3.0L Low vacume, power
This c-van has cracked 2 sets of exhaust manifold from high
heat issuses. There are no stored codes and van appeers to
run fine, but while driving it realy lacks power. A vacume
gauge reads 4 in vacume when driving 50 mph. Map sensor
confirms this with a 4.4 v... |
View |
|
2004 Dodge Intrepid 2.7L Engine
After vehicle warms up, a noise which sounds to be similar
to light valve train tapping noise occurs most noticeable
at idle. Noise goes away at approximately 1800 rpm (or at
least is not noticeable). The noise location seems loudest
with stethoscope at right ... |
View |
|
2007 Dodge Pickup 5.9L fuel gauge, brake and turn lights
The vehicle was brought in to repair the brake lights which
stayed on with the key in the run or accesory position. The
young man assigned to the truck tore into it removing the
wiring to the tail lamps and trailer connector. There is a
draw tite convertor box... |
View |
|
1994 Jeep Grand Cherokee 4.0L Convertor
Transmission works normally when cold. In less than 5
minutes, converter lock-up engages solidly. Engine stalls
when put in drive or reverse. Lock-up is so solid that if
transfer case is put in low range, brakes cannot hold
vehicle. ( I had left plenty of room... |
View |
|
2000 Jeep Cherokee 4.0L No Start, Stall
customer complained of stalling and check engine light on
with tps high & low codes. tps did not solve problem nor
did disconnecting clock spring connector as a tach
expierienced and posted in fix data base. have any jeep
techs expierienced this and what was t... Trouble codes: po123 (tps high voltage), p0122 (tps low voltage). |
View |
|
1998 Chrysler Sebring 2.5L catalyst monitor
I gave the vehicle back to the owner she drove the car for about a week she came back i scannde syatem the monetors had ran she had it re tested and it passed.think every one very much james Trouble codes: p0551 (Power steering switch code cleared it out did not come back). |
8 |
|
2001 Chrysler Sebring 2.7L Hesitation, Cuts out
CAM/CRANK NOT IN TIM [...]===3 SCANNERS SAID OK===HOOKED UP LAB SCOPE===NOT IN TIM [...],REMOVED ENGINE ADJUSTED CAM/CRANK TO CORRECT TIMING===FIXED |
9 |
|
1996 Dodge Ram Van 5.2L No Start
I recieved alot of good help, both here and in the chat room...turned out to be pretty basic, but hard to find. Somewhere in it's history, this vehicle had an add-on alarm system and a cell phone system. Looking at it made me think it had been installed by a... |
6 |
|
2001 Dodge Pickup 5.9L firing
we ending up finding the wires that run to the coil had got pinched at the very back of the intake casuing the coil to stay grounded at all times there for not alowing it to fire, thanks guys for all your help |
9 |
|
2001 Dodge Intrepid 2.7L spider gears
I replaced the LF rotor. After that the noise got much louder, at times when braking. I assumed it might be the LF wheel bearing/hub. I replace LF wheel bearing hub. The noise is better but the repetative knocking noise is still there at 30 to 45 MPH. I t... |
9 |
|
2002 Jeep Wrangler 4.0L MIL Lamp on, EVAP Code
Hello,
Had some responses pointing toward evap purge solenoid that was the fix. I did check purge solenoid with vaccum pump before posting for help and solenoid held vaccum on both ports. How I found it was faulty was by placing a vaccum gauge on purge si... Trouble codes: P0456 (evap small leak). |
11 |
|
Prev
