|
|
1998 Honda Civic 1.6L Timing Belt Marks
Hello to all and thanks in advance. I'm replacing the
timing belt on this 1.6 liter. I've done a lot of them but
never seen this before. The camshaft back cover has two
pointers for timing marks. I've always used cylinder head
surface and that's were the belt ... |
View |
|
1989 Mazda B2200 2.2L Excessive Emissions, Poor Idle Quality, Poor Fuel Economy
This vehicle has high emissions, failed emissions testing
at idle & under load. We discovered (after reading IATN for
clues) that we have no tach signal to the ecm. According to
other tech experience, the rich conditon could happen when
there is no tach signal... |
View |
|
1997 Mazda B2300 2.3L MIL Lamp on
veichle came in with po500 code,road test spedo inop.check
vss ohms out ok.all gears ok,wiring to comp ok.check a-c
voltage at comp while spinning vss,reads over 1.7
volts.ok.check spedo head per all-data,have continuity at
all 4 checks.pin 13 to term-b,pin 2 ... Trouble codes: po500 (veichle speed sensor). |
View |
|
2001 Mazda MX-5 Miata 1.8L No Start, Poor Idle Quality, Cuts out
Thanks ahead of time for any help! We have a 2001 Mazda
Miata that has been brought in for 2nd time with an
intermittent loss of power, cutting off problem, and
naturally the problem is not showing up now, but as soon as
the customer picks it up, a few days la... |
View |
|
2000 Mitsubishi Montero Sport 3.0L Compressor
After compressor and expansion valve were replaced the high
side pressure goes to 150 and the low pressure is 20,the
compressor kicks off--inside temp is 53* to 54*. Can jump
switch and temp gets down to 39*. Have checked all related
switches-all check within ... |
View |
|
1999 Toyota Camry 2.2L MIL Lamp on
I have been testing this vehicle for several weeks. engine
light usually comes on after 3rd drive cycle. Thusly
vehicle returns to me.Engine runs great 02's switching,and
have vacuum at all solenoids. To make this worse I have
another toyota come in today with... Trouble codes: p0401 (insufficient egr flow). |
View |
|
2000 Toyota Corolla 1.8L Hesitation, Misfire
Under load, the engine bogs down and has random misfires.
Ease the accelerator down, and the vehicle runs fine.
Compression, cam timing, fuel pressure, exhaust, all
checked normal. Sparkplugs are burning normal to slightly
lean. Exhaust fumes are rich and will... |
View |
|
2002 Toyota RAV4 2.0L 2-3 shift
first i'd like to say i read all the previous help
requests. the check eng light was on with a stored p0758, i
test drove vehicle and expierenced the trans shift from 2nd
to 3rd cause a bog like it was shifting into 3rd with out
shifting out of 2nd. i checked ... |
View |
|
2004 Toyota Celica 1.8L MIL Lamp on
I need help.I can not find any posts on this code.I have
ran the flow chart over and over, tested wiring,vacuum
hoses and tested the pressure sensor for voltage change at
the ecm.I ended up installing a $900 ecm with the same
results and no used ones around.I ... Trouble codes: p2441 (sec air inj switching valve stuck closed). |
View |
|
1996 Honda Civic 1.6L rack and pinion
THANK YOU FOR ALL WHO REPLIED THERE WAS A LOT OF REFERRALS TO THE BEARING PLATE HOWEVER THIS VEHICLE HAS UPPER AND LOWER BALL JOINTS THERE WAS ONE MENTION OF THE SIGNAL CANCELLING DRAGGING AND THAT SEEM TO BE THE FIX. AGAIN THANKS TO ALL. |
17 |
|
2003 Infiniti G35 3.5L Shift lock system
Thank you to the (3) techs who assisted us with the FIX of the shift interlock system. While the original problem was a lack of ground due to a bad position switch, we created a secondary problem by testing the solenoid with a PowerProbe and damaged it. By re... |
3 |
|
1998 Lexus ES 300 3.0L Surge
Thanks to all who took the time to reply. Several of you told me that you have seen this problem caused by the egr position sensor. I checked the resistance between terminals vc and e2 of the sensor, the spec is for 1.5 - 4.3 ohms, I had 5.1. I also tried look... |
5 |
|
2000 Mazda Protege 1.6L spark
thanks for all the replies,i learned alot on this system and will be more prepaired for next similar problem unit.
I went back to the power and grounds to the pcm but this time loaded the circuits with a headlamp instead of a test lamp.found the pin 71 and 97 ... |
9 |
|
2002 Mitsubishi Lancer 2.0L MIL Lamp on,
Thanks guys for all your help the problem was in the vacuum ports @ the throtle body , they were clugged and the EGR valve wasn`t getting enough vacuum Trouble codes: po401 (egr insufficient detected). |
8 |
|
1990 Nissan 300ZX 3.0L Cuts out
i had been leaning towards the tps on this vehicle but didnt have anyway to check it and when ken thomas and ross said they thought the tps i went ahead and got one and put it on problem solved thanks to all those who responded always appreciate all ideas |
7 |
|
2001 Nissan Maxima 3.0L MIL Lamp on
vehicle was sent to dealer for software upgrade but we decided while going there we would update MAF and flash for both and customer has been a happy camper since. MAF was cheap and good insurance while idle relearn seems to have helped.
Thanks everyone. Trouble codes: P0505 (idle system failure). |
8 |
|
2004 Nissan Altima 2.5L steering pump,/ rack
hello, would like to thank everyone who replied, the fix for this nissan was the lower steering knukle at rack&pinion, as many of you had said. I removed the shaft and it was very stiff. I was able to free up with penitrating oil for now, as costumer needed ca... |
9 |
|
1996 Toyota Corolla 1.6L Starting
thanks to all of you guys, the customer left the shop one week ago with a big smile.The problem was the fuse box on the left fender,thanks again! |
16 |
|
2004 Toyota Prius 1.5L Mechanical
Thank you all who replied. I didn't actually pull the engine and trans to do this job as I was told to. I removed the timing chain cover, valve cover and anything else that you need to remove upper oil pan. I reassembled and it does not leak. The reason you... |
12 |
|
Prev
