|
2003 Honda Accord 2.4L 3-4 shift
Hey All,we have this accord that has a delayed 3-4 shift @
45-60 mph.We back probed the ecm and can see the command I
beleive it's solenoid A that is affected.Has anybody run in
to this problem?We did replace the linear solenoid.It also
had a shift problem @ l... |
View |
|
2003 Honda CR-V 2.4L axles
Customer complaint is vehicle shakes on accel from a light
and accel through a left turn. Ran car on the hoist with
slight brake pressure an can get it to shake quite
violently. Disconnected rear drivshaft completely and still
shakes on the hoist. Whole eng. a... |
View |
|
2002 Hyundai XG350 3.5L MIL Lamp on,
Fuel Cut Valve and gas cap replaced by dealer,I have
replaced the Canister Close Valve,chasing po455 large evap
leak,smoked 3 times now,cannot find leak,clear code,drive
vehicle 3 drive cycles no ck engine light. Customer takes
car and is back in a day or 2...... |
View |
|
1996 Mazda B2300 2.3L Surge, Cuts out, Stall
I got this truck in an it is stall some kind of bad. Its
almost like the cyclinders are being kill and then picking
back again really fast. I have seen this behavior before on
MAF but that is the problem.
The po320= successive erratic profile ignition pickup... Trouble codes: p0320 (successive erratic profile ignition pickup). |
View |
|
2004 Mazda 6 3.0L MIL Lamp on
well ive got a mazda 6 that i replaced the engine with a
used one.its a 3.0 vct engine. i replaced the wiring
harness off the old engine to the used one. the problem im
having is the hard fault codes for both cam sensors. when
you start it up the check engine ... Trouble codes: P0340 (cam sensor), PO345 (cam sensor). |
View |
|
2000 Mitsubishi Galant 2.4L Charging
This vehicle came to us from another shop. We have no idea
what they did other than replace the alt. It still wont
charge properly and the light is on, on the dash. Alldata
is not much help on this thing and neither are the wiring
diagrams. As stated before, t... |
View |
|
1985 Nissan 300ZX 3.0L Cuts out, Misfire
suspect ecu--actually runs pretty good right now but still
has code 23-idle switch--hoping someone has a memory better
than mine that might be able to enlighten me. hesitant to
replace ecu as it does run fairly well but skeptical about
stored code-customer is ... Trouble codes: 23 (idle switch). |
View |
|
1998 Nissan Altima 2.4L MIL Lamp on
This car came in for diag. after failing pa state emissions
for check engine light on. Code PO725 - eng. spd. snsr.
malf. Poor signal w/glitches found at 1 degree wire with
labscope. replaced distributor, no change. replaced CKP
sensor on trans. bell housing -... Trouble codes: po725 (engine speed sensor openshort). |
View |
|
2001 Nissan Sentra 1.8L cooling fans
This car overheats if the AC is switched off because the
cooling fans only run with AC on. I've checked fan
relays,ECT sensor, and voltage and ground circuit to the
ECT sensor (from ECM). All looks OK with the info I have
available in Alldata. Alldata info say... |
View |
|
2002 Nissan Sentra 1.8L Hesitation, MIL Lamp on
well here is my problem child customer was recommed to me
to see if we can fix the problem,the complain was check
engine light on and no rpm signal on the dash.we pulled
codes and found po335 crank sensor and po725 no engine
speed signal to tcm,we tested crank... Trouble codes: PO335 (ckp sensor circuit problem), PO725 (no engine speed signal to tcm). |
View |
|
2004 Nissan Sentra 1.8L Poor Idle Quality, MIL Lamp on
This one came in with a check engine light on and a
intermittent stumble when first starting hot or cold.
Scanner found code P0507 stored in memory. The idle is more
than target speed. And it is, target is 850, real idle is
at 1350rpm. Check PCV system. Checke... Trouble codes: P0507 (idle control circuit). |
View |
|
2004 Nissan 350Z 3.5L Wont rev out
Would like any info I can get to fix this code "P1136 -
Intake valve timing control solenoid valve". Codes sets as
soon as you start to drive and as a result engine wont rev
past about 4000rpm. Location of part and any test procedure
would be of help. Nissan d... Trouble codes: P1136 (Intake valve timing control solenoid valve.). |
View |
|
1989 Toyota Land Cruiser 4.0L Cuts out, Misfire
Problem occurs on acceleration. You can feel it just before
shifting to second on a WOT and when you get to 3rd gear,
it will run up to about 66 mph and cut out and not
accelerate to the next gear. If you let off the gas so it
upshifts, you can accelerate to h... |
View |
|
1995 Toyota Pickup 2.4L No Start, Hesitation, Surge, Cuts out, Stall
Vehicle came in 2 weeks ago with skip. Found #3 wire burnt
thru on manifold. replaced cap rotor wires plugs with new.
truck ran great. came back in last week. died on customer
in city. cranked but no start. after sitting 1/2 hr started
back up. ran rough for 1... |
View |
|
1997 Toyota RAV4 2.0L abs
Hello again and thanks in advance. I have a problem with
this Rav 4. The customer stated that the brakes dont feel
right and when I drove it I understood what was going on.
It seems that the ABS activates as your comming to a stop.
There are no codes stored. O... |
View |
|
1999 Toyota Camry 2.2L catalyst monitor not
hello guys ,this car came in for check engine light on.we
hooked the scanner and found these cods,which we repaired
by installing new vsv,and purge control solenoid,and after
ward we didn't get these codes.now the problem is that the
guy wants to get the airca... |
View |
|
2001 Toyota 4Runner 3.4L Excessive body sway
Hi all
Customer bought this 4Runner 3 weeks ago. He began
complaining almost immediatly about ride quality. He
describes being blown off course on windy day, making
excessive steering corrections to maintain straight line.
I have driven and driven and drive... |
View |
|
2004 Toyota Sienna 3.3L spark plugs
hi guys , just a quick question on this van , does one have
to remove the intake plenum to axcess the rear spark plugs
, and is the gasket on the plenum reuseable , i have not
run into this before , and aldata does not mention removing
the plenum . thanks for ... |
View |
Prev
