|
|
1956 Ford Victoria 292CID Engine
I am looking for something that I may have overlooked. We
R&R'ed the engine for rebuilding a few years ago. The
engine now has about 500 miles on it and it is leaving oil
puddles wherever it is parked.
After the first 100 miles, the car started leaving sizeab... |
View |
|
1993 Ford Mustang 2.3L Starting
the car is starting like its out of time ,it bucks and
jerks back while cranking. weve replaced the crankshaft
sensor and the ignition control module.the customer told us
it has been doing this every once in a while but now it
does it on every start up.when bo... |
View |
|
1994 Ford Probe 2.5L spedometer
HELP!!! Thanks to all who reply.I'm having a hard time
with this probe and it should be easy.No speedometer and
odometer.Check vss with Hz and it would start low and climb
high the faster you went.so we checked wires for opens or
shorts from senser to cluster.... |
View |
|
1996 Ford Econoline 5.0L Rear Air
Van has front and rear air conditioning. Rear air blower
will not blow, checked the 50 amp fuse in the power box
under hood, it is good. Front ac blows and cools fine.
Unable to locate other fuses or power coneections in rear,
but haven't taken trim apart. |
View |
|
1999 Mercury Sable 3.0L No Start
Hello everyone and thank you in advance for help on this
vehicle. Vehicle was initially towed in as a no start
problem. However, vehicle started right up upon arrival.
Vehicle started all that day without a problem. The
following morning vehicle started up and... Trouble codes: P0320 (ignitiondist engine speed circuit fault). |
View |
|
2000 Mercury Sable 3.0L Poor Idle Quality, Hesitation, Misfire
we replaced the crank sensor and plugs now the car starts
,stumbles bad there are no code the mode 6 is $10-$26-$00
we do not know what the code is,tested the cam,maf
egr,iac,every thing we could think of |
View |
|
1989 Merkur Scorpio 2.9L Mechanical
I have this merkur that will not pull. The owner said it
has done it before and that the shop built the trans but
all that was wrong was a seal had blown. He was told this
is a common promblem with this trans. What I need to know
is the seal that is so bad to ... |
View |
|
1994 Ford Ranger 4.0L No Start, No ECM communication
Thanks for all the replies. After checking all grounds and power to the ECM, one of the last checks on the Alldata was the power diode. Fix was bad power DIODE located in relay box under the hood. |
7 |
|
1995 Ford Escort 1.9L lap belts
HI THERE, TURNS OUT MY SEAT BELTS ARE OK. THE REPLIES I GOT WERE TO LOCK UP THE BRAKES AND CHECK IF THE BELTS LOCK UP AS WELL. I HAD TRIED THAT BEFORE MY POST, BUT I TRIED IT AGAIN AT ABOUT 20 MPH. I STOPPED QUICKLY, BUT DID NOT SKID, THE BELTS DID LOCK UP THE... |
7 |
|
1998 Ford Explorer 4.0L Timing chain noise
Thank you to everyone who responded. Yes the rear guide was broken. The consensus was to remove the engine to replace the rear cassette. I chose to remove the trans instead. My logic was less items involved to do so. All went well, until it was time to re... |
10 |
|
1999 Ford Pickup 7.3L gem module
new gem installed and draw gone. New one takes 30 min to time out. thanks for the help |
4 |
|
2004 Ford Pickup 6.0L oil pressure
Hello all, Ive had six replies, for my comcern, thanks for the advice, I was correct ,it was cause by Tech error, when replaceing the Eng Oil Cooler the valve in the oil filter adapter housing broke, causing restriction , replace adapter ,and oil pressure was ... |
6 |
|
2005 Ford Pickup 6.0L front end
its fixed the bushings in the arms that go from the frame to the front end were repaired and drives smooth now thanks everybody!!! |
8 |
|
2002 Mercury Mountaineer 4.6L back up sensor
found two seperate problems. for the alarm we found that the passenger door switch was faulty and influensed by colder tempatures causing the alarm to sound in the middle of the night. on the back up sensor had to use a otc scanner to get access to p.a.m. park... |
3 |
|
2002 Mercury Sable 3.0L oil leak
Thanks for all replies I replaced oil pan gasket and crank sensor pan gasket was leaking pretty bad crank pulley was probably whipping oil around!I will tell you one thing this is alot easier to do then the Jags! I am sorry about any confusion on oil leak loca... |
6 |
|
Prev
