|
|
1995 Ford Econoline 5.8L Parking ratchet
When I apply the parking brake and then release it the
ratchet does not return the cables far enough to release
the shoes. I have replaced all of the cables and the
ratchet twice with no difference. I can pull the cable back
with my hand and then the shoes wil... |
View |
|
1995 Ford Pickup 7.3L Excessive Emissions, Poor Idle Quality, Cuts out, Misfire
Iam not a diesel tech but this powerstroke belongs to my
brother and its how we get our dragster to the track. Its
doing a few odd things. First, the battery voltage does not
increase right after starting the engine, rather it takes a
few minutes and then the ... |
View |
|
1998 Ford Contour 2.0L driver side CV axle
Can you knowledgeable technicians recommend a removal
method for the driver side drive axle? Per the Haynes
manual (chapter 8, section 8-6) the axle is removed by
placing the trans in Park, then use a lever such as a 16"
pry bar between the inner CV joint and ... |
View |
|
1999 Ford Windstar 3.8L No Start, Stall, MIL Lamp on
Hey guys. Here is one that I have not seen before. Vehicle
started out stalling sometimes as if a bad IAC with no
codes. It would not do it when at the shop. Then started
stalling while going down the road and set the P0320 code.
It would start back up found n... Trouble codes: P0320 (ignition diagnostic moniter). |
View |
|
2004 Ford Pickup 4.6L Mechanical
Customer was driving truck and heard a noise, pulled over
and heard a ticking/tapping/clacking noise. We towed it in
and began diagnosis. Noise sounds like it is in the valve
train area and is a "tiny" clink clink clink (steady there,
a little worse when warm,... |
View |
|
2007 Ford Pickup 6.0L suspension
hi,
i'm working on a 2007 f350 super duty. 6.0 diesel. owner
complains of shaking and loss of control when he hits a
bump at high speed. alignment is good. tires are new and
balanced.the front end is tight.retorqued all fastners i've
seen this on jeeps but ne... |
View |
|
1993 Ford Ranger 4.0L clutch hydraulics
Thxs for all of the good replies- after making sure we had bled all air out(we are now experts at this function) indeed, we did have to pull trans back out & measure flywheel to a new flywheel- we could not find any specs on flywheel thickness- it was .025 thi... |
45 |
|
1996 Ford Econoline 5.0L Rear Air
Replaced aux switch. No resistor in back as advised. Ford A/C's are notorious for melting switches/fueses, etc. |
11 |
|
1999 Ford Pickup 7.3L System
I want to thank all those that provided help. As I said in the beginning the solution was right in front of me but it did not make sence.
There is nothing wrong with the system! It was designed to operate the compressor in all modes except panel only and f... |
9 |
|
2004 Ford Pickup 6.0L MIL Lamp on,
Well did as most suggested and went ahead and replaced the iat#2 in the manifold has been a week know customer says so far no more light and runs great, thanks. Trouble codes: P0401 (insufficient egr flow). |
7 |
|
2004 Ford Explorer 4.0L Poor Idle Quality
I checked the balancer on the crank, and the weight on the inside was broken. I replaced the balancer and the idle quality smoothed out. Thanks to all who replied! |
14 |
|
2005 Ford F550 Super Duty 6.0L Chuggin back intake
Special thanks to all the reply's! Everyone hit it on the money. Tried cleaning turbo and egr passages referring to ford TSB. Noise still persists. Sent to dealer for warrenty turbo replacement due to Variable vanes in the turbo sticking
letting the boost ... |
12 |
|
2006 Ford Pickup 6.8L rf speed sensor
Thanks for all who replied. I am grateful. The customer is an oilfeilder and declined the repair due to plans of trading the truck off. Thanks again |
8 |
|
1997 Mercury Grand Marquis 4.6L Electronic
i check more in to it found no signal came out of tempt. control panel replace panel work great thank you for all your help |
5 |
|
Prev
