|
|
1995 Ford Econoline 5.0L Vaccum Door motor
We have a Ford E 150 conversion van. Heat and AC work great
but when going down the road under load (engine vaccum
drop) the door which swaps from vent to defrost closes and
blows air out the defrost. When load is removed and vaccum
is restored the door opens.... |
View |
|
1995 Ford Econoline 7.3L Front Brakes
Hello everyone. We have a Ford E-350 Ambulance package with
four wheel antilock - customer compliant brake pull to the
right. Road test revealed braking action under hard braking
conditions was normal (with the exception of rotor shake)
the first time brakes w... |
View |
|
1998 Ford Explorer 4.0L timing chain noise
hi, i just finished replacing the l/f timing chain cassette
& tensioner (guide was broken but still there). after
restart the engine is still very noisey in front. we made
sure to torque all of the pulley mounting bolts. the motor
hadn't jumpped time. any idea... |
View |
|
2001 Ford Pickup 7.3L Cruise Control
Truck came in with cruise inop, light dose not come on on
dash. No codes in GEM , when I monitor switchs with Gensys
switch voltage changes when I push buttons. Different
buttons & different voltages, so I assume switch & clock
spring is good. All-Data is very... |
View |
|
2004 Ford Escape 3.0L Reverse
Customer noticed delay into reverse when vehicle warmed up.
Delay got worse over a period of about 3weeks until there
is no reverse at all when hot. When vehicle cools down
overnight you have reverse again until engine is warm or
you have travelled about 5 mil... |
View |
|
2004 Ford Pickup 4.6L Mechanical
Customer was driving truck and heard a noise, pulled over
and heard a ticking/tapping/clacking noise. We towed it in
and began diagnosis. Noise sounds like it is in the valve
train area and is a "tiny" clink clink clink (steady there,
a little worse when warm,... |
View |
|
1994 Lincoln Town Car 4.6L caliper
After driving on the highway for 100 miles suddenly heard a
clunk and the cruise cut out, began to lose power, brake
pedal was high and firm (felt like it was pumped up),
stopped and found smoke coming from right front brake
caliper/pads/rotor and red hot. Aft... |
View |
|
2005 Other Ford Caterpillar 7.0L Excessive Emissions, Cuts out, Misfire
This problem occurs only Between 1000 - 2500 rpm , water in
fuel indicator lights up, excesive white smoke on exhaust
and lacks of power). Tried to pull codes using quick check
III and found no codes. Only flash code 34. I have not much
experience in HD and I'... Trouble codes: 34 (Flash code no description). |
View |
|
1985 Ford Ranger 2.8L Ignition key lock
Thanks to all of you that sent help, a lot of the ideas were similar, so I see that this problem has happened to many of you before.
I ended up doing a combination of drilling out the cylinder and using a slide hammer to remove the lock assembly. It got messy ... |
30 |
|
1987 Ford Club Wagon 5.0L Poor Idle Quality, Stall, Poor Fuel Economy
after disconnecting the return line, putting a hose in a bucket and starting the engine, the fuel pressure dropped to the normal range. tracing back to the fuel reservoir and selector valve,we found a restriction.we are now trying to find obsolete parts on the... |
11 |
|
1998 Ford Windstar 3.8L overdrive
hi all, i did not get the chance to look at this further as the customer took the van and i have not seen it back. most replies were for a broken band or bad solenoid.i will update if fixed. thanx to all
dave |
11 |
|
2002 Ford Escort 2.0L engine/car
We tried & tried to eliminate this vibration as stated in original post, condition did improve, but was still evident. Many replies stated that several similar vehicles also still had an inherent vibration. Checked cam timing as per one suggestion, was okay.... |
10 |
|
2003 Ford Pickup 4.6L No Start, Cuts out
Well it's fixed, but a dealership did it. Not me. When the next rain storm came and it still quit running even though the windshield was resealed, my customer decided it was time for a new one, so he traded it in, but he hung around long enough to see what... Trouble codes: P0320 (IgnitionDistributor Engine Speed Input Circuit), B1318 (Low Battery Voltage At Module). |
4 |
|
2004 Ford Explorer 4.0L steering
Hey Guys, Thanks for all the suggestions. Turns out the problem was not in the steering at all. The problem was chattering clutches in the rear differential. We came to that conclusion after all else failed to work and decided to gamble with having the rear cl... |
9 |
|
Prev
