Prev iATN Members TechHelp for May 15, 2008
Automotive Technical Exchange for the Automotive Repair Professional		 Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2000 Chrysler 300M 3.5L temp
Customer complains of mist from ac vents at times and also having to constantly having to adjust heat temp. We scanned all on board system, re calibrated doors, scanned with snap-on diagnostics. No codes found and no previous problems found. According to scan ...		 View
2000 Chrysler Concorde 2.7L master cyl
brake petal fade feels like faulty master cyl,replaced master cyl bleed system.same condition remaned part replaced master cyl again thought maybe bad part ,still same problem.with car off pedle will stay up with no fade,when car is started pedle fades to floo...		 View
1995 Dodge Pickup 5.2L Cuts out, Stall
this truck has a stall after a long hot soak. after 20-45 min you start it it runs fine. you try to put it in gear and it dies. it will stall 5 -10 times and then all is ok till you let it sit. i have cleaned the throttle body and replaced the iac. i reset the...		 View
1998 Dodge Intrepid 3.2L No Start
hey chrysler techs ihave a dodge intrepid 98 with a 3.2 car came in customer said it stalled checked fuel pressure no pressure checked fuses and relay ok checked for codes none found installed fuel pump still wouldnt start after looking more into it found harn...		 View
1999 Dodge Intrepid 3.2L Body Module/a/c
Ok, a/c compressor would not engage. Can engage with command from scanner (snapon modise), Had multiple body control module faults /courtesy lamp output failure/fuel sending unit failure/evap sensor failure/incar temp sensor failure/atc mode door feedback fail...		 View
2000 Dodge Intrepid 2.7L rich, -25% fuel trim
I can see that everyone loves the 2.7l engine! Now its my turn. This vehicle came in with the mil illuminated, a stumble and rough run on cold mornings. I checked the code, a P0300 random misfire code, and it does misfire on cold start up but as soon as it g... Trouble codes: P0300 (random misfire).		 View
2001 Dodge Grand Caravan 3.3L Unknown
Customer came in complaining of a vibration under accel. around 45mph. Test drove vehicle and confirmed problem. We did notice a strong torque pull to the right under accel. The vehicle has a real noticable shimmy feeling around 45mph under accel. but immediat...		 View
2001 Dodge Pickup 5.9L MIL Lamp on
hey dodge guys ... this truck has a check engine light scanned the computer with a modis scan tool and found no codes??? if you clear the computer the check engine light will go off for about 20 miles then turn on again with no codes. tried to scan the body co...		 View
2002 Dodge Neon 2.0L Poor Idle Quality, Cuts out
This is an odd one. Idle is ok without a/c on, but when the a/c is on there is an irregular idle drop. Idle rpm will be 720 +/- 20 and there will be a momentary drop to the low 600's. There is no pattern and I am unable to cause this event to occur - it simply...		 View
2006 Dodge Pickup 5.7L starter
Have a starting problem with this hemi,PCM pulses stater relay control pin# 38 connector #c3? Tested all grounds at PCM good,if I ground wire at relay, starter cranks perfect? Dodge had truck for 2 weeks could not fix they did change PCM.		 View
2004 Jeep Wrangler 4.0L MIL Lamp on
I am looking for some assistance from a Jeep tech. This vehicle has a intermittent reoccuring fault code P0456. The gas cap is new and the leak detection pump has been swapped out with known good one. It takes between two to three weeks for the code to reset a... Trouble codes: P0456 (Evap System Very Small Leak Detected).		 View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2001 Chrysler Sebring 2.7L MIL Lamp on
Sorry guys, after much thought i have decided to quit. I don't do that often but oh well. The customer is not willing to spend for more dig time or "known good parts". Trouble codes: P0108 (MAP Circuit High Voltage), P0172 (Rich bank 1).		 12
2005 Chrysler 300 3.5L window
the regulator/motor is a one piece and as mentioned by several, replaceing part fixed problem, thanks for all the help. Brian.		 5
1995 Dodge Ram Van 5.2L No Start
Thanks to Auston from S.D., he was right, turned out the coil driver in the pcm was bad, got another pcm from a different manufacturer and it runs great. I knew these had weak coils but it's the first time I experienced the actual driver going out. I had the...		 6
2000 Dodge Caravan 3.3L Unknown
changed rear propotioning valve and left front caliper.fixed problem thanks for everyones help		 16
2000 Jeep Cherokee 4.0L Engine
Thanks to all that replied. I installed a new balancer on the front of the crankshaft and it improved it slightly so I opted for a performance balancer by Fluidampner. This fixed it completely. The old balance was not seperated and the timing marks lined up...		 8
1994 Plymouth Voyager 3.0L Battery
Well, the fix is in. It ended up being a bad battery, sulfated and not taking and holding a charge at times. After replacing the battery and doing another round of testing all seems ok. I got it to a vat and found that with the old battery it would only put ou...		 23
1998 Plymouth Breeze 2.0L No Start
good evening everyone.sorry for not closing earlier but i was waiting for customer to decide what he wanted to do.well first,id like to say thanks to those that responded to my help request.i appreciate your time and knowledge.i received info from timing belt ...		 14
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next