|
|
1971 Chrysler Imperial 440CID No Start, Hard start
We did the follwing: Replaced point, cond, and ign coil..
coil was leaking Replaced fuel pump with new and replaced
metal line to carb with rubber.. Installed new Edelbrok..
carb.. Set timing and carb Tested battery and starter.
Starts right up cold.. Starts ... |
View |
|
1995 Dodge Pickup 5.9L no 3-4 shift or convertor lock-up
This truck was refered from trans shop. They rebuilt unit
and it worked 6-8 weeks then would not shift 3-4 or
lock-up. They fount tps reading of 5v on scan tool, still
reads 5v with tps disconnected. Removed wire from pin#22 at
ecm and scan tool reads 5v on tp... |
View |
|
2000 Dodge Durango 4.7L Poor Idle Quality, Hesitation, Surge, Stall, Misfire, Poor Fuel Economy, MIL Lamp on
this durango came in runing poor and fuel pressure was 15
psi so we replaces the fuel pump and after it runs for
about three minutes the engin starts to surge and the fuel
pressure is at 50 psi. when it acts up the asd and fuel
pump relay start to click or dro... Trouble codes: P1282 (fuel pump relay circuit), P1495 (ldp sol circuit), P1388 (asd relay circuit), P1491 (fan relay circuit), P1389 (no asd relay boptput at pcm), P0622 (generator field not switching). |
View |
|
2006 Dodge Pickup 5.9L initial take off
this truck has a shutter type feel on initial take off at
about 8 mph and then goes away and is not felt at any other
time. you do not feel this going backwards. there is a tsb
on hunting for 1 to 2 shift, but this feels to early for
that. this truck does have... |
View |
|
1992 Eagle Talon 2.0L cylinder compression
the valves were bent. had a machine shop replace all
valves. installed head and new timing belts. have checked
the timing of the belts at least 3 times. everything lines
up. no compression in any cylinder. put the snapon leakage
detector in cylinders and have ... |
View |
|
1999 Jeep Grand Cherokee 4.0L power windows,ac system
Hello,
I have this 1999 Jeep Grand Cherokee with body control
faults.The power windows,ac system and interior lights
failed all at once,and as I am not really a Jeep guy I
could use some help.
I scanned the body control module an came up with these
unnumbere... |
View |
|
1997 Plymouth Neon 2.0L No Start
Good Morning
We have this 1997 Neon that requires a PCM replacement. (no
reference voltage to the sensors,shorted out camshaft
postion sensor). It is being supplied by A1-Cardone. They
will flash the unit before shipping {Calibration
Pre-Flashed at Factory}, ... |
View |
|
1997 Chrysler Cirrus 2.5L No Start
As many of you said, it was the distributor. The description and operation section in Alldata led me to believe that this system works like other Chryslers, where the PCM controls spark directly. This system uses a VERY low voltage signal to fire the module. T... |
6 |
|
2000 Chrysler Concorde 2.7L master cyl
customer has installed front left caliper wrong and there was to much movement causing soft petal. thanks for the help |
3 |
|
1996 Dodge Pickup 5.9L Charging
Thank you all for your help,i deside to pull the eng wiring harness,at the rear of cycl heag i found the asd sensing(green/red) and the feild control was rubbing against the fuel line which is part rubber and part metal.it was rubbing against the metal part wh... |
10 |
|
1996 Dodge Pickup 5.9L Hesitation, Stall
Thanks for all the replies, unfortunately my manager gave up on this truck before I did. (went back to customer still smoking, with hesitation) After clamping the fuel return line I got a bit more power out of the truck, so I replaced the fuel return check va... Trouble codes: p1757 (governor zero pressure malfunction), p0720 (output speed sensor circuit), p1389 (no ASD relay output voltage at PCM). |
9 |
|
Prev
