|
|
1995 Chrysler Cirrus 2.5L key fob
Attmpting to program new fob using DRB3. Body computer
shows going into progam mode but comes out of programing
when I touch either of the remote buttons. Is there some
kind of trick that I'm not reading about? Any help wou;d be
greatly appreciated. Paul |
View |
|
2004 Chrysler Town & Country 3.3L Stall
I have a 04 chrysler town and country with a 3.3 liter.It
will intermittently stall while driving 30 to 40mph.There
are no warning lights on and gages not reading anything.The
van will restart right away and go for a couple of weeks
before it happens again. |
View |
|
1998 Dodge Ram Van 5.2L No Start, Surge, MIL Lamp on
Replaced CKP, CMP, PCM, IAC, Plugs, Rotor, Cap, Coil,
Wires. After replacing all of these items the code P1391
still comes back. Replaced the PCM because the IAC Test
failed. Checked all wiring, OHM and Voltage were all good.
Before replacing the coil, cylinde... Trouble codes: P1391 (Intermittent Loss of CMP or CKP), P0505 (IAC Motor), P0320 (No Crank Reference at PCM). |
View |
|
2006 Dodge Pickup 5.9L Cuts out
First of all thank you for taking the time to read this
e-mail. Trying to get some help on this truck.The customer
complaint is that engine will die, only when the fuel tank
is halfway full.this never happens with a full tank of
fuel. Scanned all computers and... Trouble codes: P0148 (Fuel delivery malfunction). |
View |
|
2000 Chrysler Sebring 2.5L Oil slow to return to oil pan
Thanks guys,
Since the front bank was as clean as it was I decided to flush again. When drained after the second flush the oil was mostly clean but there was some debris. Changed filter, refilled with oil and let idle for about twenty minutes. Oil appeared to ... |
10 |
|
2001 Chrysler Town & Country 3.8L reverse
Found trash on speed sensors and pan. Warranty company wanted a tear down. I don't rebuild. Sent to Warranty company's choice of trans. shop. They found stripped planetary. Rebuilt trans. and everybody is paid and happy. |
12 |
|
2006 Dodge Pickup 5.9L Compressor
Thanks for the replies. This system does not have an AC relay. The AC pressure was high enough that the Compressor should run. Checking all of the temp. sensors was suggested, they seemed OK. Several replies pointd the the TIP Module. Since I could not access ... |
10 |
|
Prev
