|
1989 Ford Econoline 4.9L Excessive Emissions, Poor Idle Quality
Customer brought us vehicle to rebuild engine due to wear
and failed emissions test for high HC. While the engine was
out we sent the fuel injectors out to be cleaned and flow
tested. Also noticed a lot of fuel in the pcv hose during
engine removal so we repla... |
View |
|
1990 Ford Pickup 4.9L fast idle
the customer had truck towed in , said that it stalled out
and would not start.when truck came in the truck started
but it had a idle of 2000 rpm.found a vacuum leak at the
throttle body. i have squirted for a vacuum leak , none
found , unplugged and taken com... Trouble codes: 23 (tps out of range). |
View |
|
1994 Ford Mustang 5.0L radio
this car has the premium sound system with front and rear
sub amps. the problem is intermitant. sound is normal most
of the time but eventualy there is a reverberation and
static sound that develops and becomes very loud. the
sterio must be turned off and on a... |
View |
|
1998 Ford Taurus 3.0L MIL Lamp on
OK guys, I could really use help with this one. This car
came into us
with a check engine light on, and a quick check of stored
codes
revealed a P0443 ( EVAP control system canister purge valve
circuit malfunction)
and a P0455 (EVAP control system leak dete... Trouble codes: P0443 (EVAP control system canister purge valve circuit malfunction), P0455 (EVAP control system leak detected...no purge flow or large leak). |
View |
|
1999 Ford Contour 2.0L timing belt
i recently towed this car into my shop and it was barely
running when we picked it up like like it was low in time.
i got it in my shop and by the time i got it in here it
wouldnt run at all i checked the compression first and
noticed it only had about 40 poun... |
View |
|
2001 Ford Pickup 7.3L Oil Pan
Hi fellow IATNers.
Quick question, does anyone have any shortcuts for
replacing the oil pan in this vehicle? Shop Key says to
pull engine. Can I remove the turbo and jack the engine up
enough to clear the crossmember, or do I have to yank this
anchor ? As al... |
View |
|
2003 Ford Pickup 6.0L Surge, Cuts out, Stall, Misfire
snap on 2500 scanner says error occured return code quit
running only when hot black smoke missing wont rev at all.
the scanner does not say no communication.it says an error
occured return code :(ox1)[#3] what is this ? i have had a
jeep whith a bad crank sen... |
View |
|
2005 Ford Pickup 5.4L Steering
OK, this truck has a subtle but very noticable
knocking/slight shudder when turning a corner ( like at a
stop sign) the problem has been there prior to the ball
joint problem. The vehicle has to be under power, do not
feel anything when coasting, mild corners ... |
View |
|
2001 Lincoln LS 3.9L Poor Idle Quality, Hesitation, MIL Lamp on
Hello all.
We have this 3.9 Lincoln here that broke the shoe off of
the left aux. cam chain tentioner and sent the exh. cam 3
teeth out of time causing the engine to run on the right 4
cylenders. Pretty straight forward 'till we fixed the
timing for the left ... Trouble codes: PO340 (cmp ckt malfunction). |
View |
|
2002 Mercury Mountaineer 4.0L intermeadiate shaft rear drive gear and cam chain
this vehicle was towed in a no start condition.customer
reported that the engine would crank but would not start
and run.we found the bolt that secures the driven gear on
the rear of the intermeadiate shaft for the passanger side
cam chain had sheared off.we r... |
View |
Prev
