Prev iATN Members TechHelp for June 4, 2008
Automotive Technical Exchange for the Automotive Repair Professional
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1997 Ford Ranger 4.0L die when hot
Hello , they brought in this ranger saying it will ocasionly die going down the road when hot(engine and air temp). restarts after several minutes and runs fine again. everything scans good and looks normal, can't seem to duplicate. IF it had a seperate module...
View
1999 Ford Taurus 3.0L Defroster door vacuum control
Vacuum control will not hold vacuum to close door and then direct air flow to vents. Used vacuum pump to apply to yellow line to vacuum motor/actuator. Can this vacuum (motor/actuator)control be replaced without removing the instrument panel to gain access? Th...
View
1999 Ford Windstar 3.8L Surge, MIL Lamp on
This vehicle belongs to my neighbor, it is tripping a lien fault for both banks. She is also stating that it is surging. I am great with VWs, but dont see too many fords in our shop. We are looking for what is common on this to cause a lien fault. No noticeabl...
View
2000 Ford Taurus 3.0L fuel gauge
I have had this happen twice to this same type 2000 taurus. One is my dad and Im asking him to live with it the other is a customer. I have just done a motorcraft fuel pump and have a fuel gauge that goes empty and puts the fuel low light on very intermitantly...
View
2001 Ford Pickup 4.6L MIL Lamp on
During FIRST mile of test drive, EGR vac is coming on and EGR is operating normally. SECOND mile of test drive, EGR vac suddenly drops to zero and continues not to work for the rest of test drive. Return to shop, turn key off, restart engine, and repeat test d... Trouble codes: PO401 (Insufficient EGR Flow Detected).
View
2002 Ford Ranger 4.0L 4wd module
no communication with the four-wheel drive (4wd) control module with the scan tool. after following all the tests in the diagnostic tree the result says to refer to module controls network. what should i check next?
View
2002 Ford Ranger 2.3L noise
We have this [...] that has a heavy rattling noise in the rear engine area. With ac on at idle in gear or when trans is shifted between drive and reverse and back. Sounds like a cat bed rattling but have tryed hitting exhast with no luck. Noise is most pronounc...
View
2002 Ford Expedition 5.4L Surge
hello everyone, customer states that engine will rev up by itself with foot on brake , a/c on at stop light, and they say radio volume increases by itself when this happens, I can't get it to do it, no codes, runs perfect otherwise, they are also compaining ab...
View
2003 Ford Focus 2.0L No Start
Hey guys can you tell me if you have to pull the tank in order to change the fuel pump. nodatta has nothing on this subject and MOD says to pull the tank. I would look for an access hole inside the trunk area but theres boom box gear there i dont want to mess ...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1994 Ford Mustang 5.0L radio
I have not total fixed this car but after inspecting all wires under the rear seat and letting it dry out for a few days the problem has become very intermitant. According to the customer when the buzzing starts to happen turning off and on the radio solves it...
4
1996 Ford Aerostar 3.0L O2 moniter won't set
First I'd like to thank all that replied.All had useful info. Saad from Texas suggested go into OBD II & check for pending codes,there were none.Make sure eng. temp. is correct it is.Check for shorted O2 heater circuit.We did not find any shorted heater circui...
8
1996 Ford Windstar 3.8L abs
Hi again and thanks to those that responded. I guess I didnt explain myself correctly on my post. The code was fix and test drive found all sensors to read correctly. My issue was after I clean and adjusted the sensor and after I road tested I than but the van...
4
1998 Ford Pickup 4.6L ABS module
well gentleman thanx for all yalls help, but you can chalk this one up for the iatn boneheads archives my tech who changed the calipers and put them on the wrong sides (this puts the bleeder valves at the bottom of the caliper) after i started looking closer a...
6
1999 Ford Pickup 7.3L Excessive smoke
Well, it's fixed. We got a tester and checked compression on the engine, worried about the intake tube that had been off for awhile in dirty conditions (Landscaper). The readings on bank 2, cylinders 5-8, were 310, 450, 325, 320. What?? Must have 3 low cylinde...
15
2000 Ford Ranger 2.5L No Start
i really appriciate the help and yes it still had 5v reference and sensor was unplugged just incase. well i got a ecu from a local junk yard for 100.00 and it fired right up. thanks to all who replied.
7
2001 Ford Expedition 5.4L noise
sorry it took so long had to convince father in law to replace iac and noise did go away had to justify the price of the new part
5
2003 Ford Ranger 3.0L driver window
Thanks for yalls help, it was the master switch on drivers door. Thanks again...
6
2000 Mercury Cougar 2.5L fuses
I traced the wire coming out of the ignition switch to the radio checking for any signs of grounding out somewhere under the dash and didn't find any other explanation for this problem besides the radio.I could never duplicate the problem with the radio out.Th...
2
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next