|
1992 Ford Aerostar 3.0L No Start
Hi gang, thanks for all the replies. We chose to install the 92 engine harness and PCM. I'm not going to make that stupid mistake again. I should've known better from the beginning, I'll chalk it up as a "rookie" mistake. Lesson learned. Thanks again! |
8 |
|
1996 Ford Explorer 4.0L Lighting
Thanks to Kyle [...], Brian [...],Tom [...]/[...], Jim [...], Mike [...], Donald [...], Richard [...], Jung [...], James [...] and William [...] for your replies.
Although there is no specific procedure in Alldata to diagnose this fault, The replies indicat... |
10 |
|
1999 Ford Taurus 3.0L Steering Fluid
Thanks to all the replies, we finally got the air out by just turning the wheels a lot. It really helped doing it from stop to stop without engine running. Once again thanks alot. |
13 |
|
1999 Ford Windstar 3.8L l sliding door
The fix was the optical sensor. It is a small sensor with a wire hanging from it that sits in the motor assembly. It cost about $30 and the dealer special ordered it for me. The dealer called it sliding door actuator sensor. The rear inside panel that covers t... |
5 |
|
2003 Ford Crown Victoria 4.6L Stall, START/DIE
5 of the 7 replies suggested replace the IAC. Could not see any thing else going on w/ vehilce so decided to replace the IAC as it was fairly inexpensive compared to additional diagnostic labor hours. Vehicle has been back in customers hands for 2 weeks & has... |
7 |
|
2006 Ford Taurus 3.0L anti theif
THANKS TO ALL!!! TURNS OUT THE PCM WAS THE FAULT HERE IN CALIFORNIA UNDER WARRENITY AND TOWED TO THE DEALER |
22 |
|
2000 Lincoln Continental 4.6L Poor Idle Quality, Misfire, MIL Lamp on
well pulled engine, removed broken timing chain pieces, all other chains still tight. maybe left a cam gear bolt loose? i will pull cams & check valves. anyway i will eat the repair, & double check my work in the future. thanks to all that replied. Trouble codes: p0304 (cylinder 4 miss-fire), p0305 (cylinder 5 miss-fire). |
10 |
Prev
