Prev iATN Members TechHelp for June 11, 2008
Automotive Technical Exchange for the Automotive Repair Professional		 Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2002 Chrysler Sebring 3.0L Hesitation, Cuts out, Misfire, MIL Lamp on
Thanks for your time,third shop to get this car,and its still not fixed.Problem is engine misfires under a load,it idles good and has plenty of power at higher rpms()2500).If you ease into the throttle it will pick-up and run fine,but with a quick snap it bogs... Trouble codes: p0300 (random misfire).		 View
2003 Chrysler Town & Country 3.8L MIL Lamp on
i have a 3.8 chrysler driving me to the poor house, sets lean code almost imediatly, have searched for vac leak cold and hot with smoke and with added fuel while watching fuel trims, no luck. checked fuel pressure over and over 59 lbs, volumne also good, have ... Trouble codes: p0171 (11 fuel system too lean).		 View
2003 Chrysler Sebring 2.4L locks, radio, interior light
The electric locks don't work with remote or button in car. The radio is dead and the interior light does not work. All of the fuses are ok. That was pretty much all I had time to check. The customer hoped it would be a quick and easy. This car is coming back ...		 View
2002 Dodge Pickup 3.7L MIL Lamp on
truck came in with ses light on had code po171 lean and po133 which is 02 slow response,replaced 02 sensor still has same problem,i back probed pcm 02 signal wire black/green and found 0.00 02 volts,checked wire from pcm to 02 harness and found open when i loo... Trouble codes: PO171 (lean), po133 (02 slow response).		 View
2003 Dodge Caravan 3.3L security system
this van has a security system problem that very intermitent, 2 or 3 times a week, customer says that it will start and stall a few times then just refuse to turn over, if he walks away from it for 20 minutes it will usually startand run fine, I've had this va...		 View
2003 Dodge Pickup 5.9L speedo
Thanks for any help guys and gals, When sitting in Park, reverse and neutral, the speedo needle bounce from zero all the way to 120mph and it actually adds miles on to the odometer, disconnected VSS, no change, when driving down the road, it is less frequent b...		 View
2006 Dodge Caravan 2.4L low power/smothers
it will run great most of the time...when problem shows up, engine feels just like a weak egr valve allowing exhaust gas to be induced at too great of a volume(this california emissions engine has no egr!!!).never dies. only smothers back while accelerating. i...		 View
1987 Jeep Cherokee 4.0L Hesitation, Cuts out, surge@times
this truck has a 30 to 40 mph hesitate and surge under load,also will somtimes hesitate and backfire with heavey accel from idle.pulling what little hair i have left out.		 View
1995 Jeep Grand Cherokee 5.2L Poor Idle Quality, Stall
Thanks to any one who takes time to read this. Need a little guidance on this vehicle. Intermittent stall/rough running. Started basic. DTC 21-oxygen sensor voltage high. Oxygen sensor reading 5.00volts on scan tool. Noticed MAP,TPS,IAT,&ECT all have splice 10... Trouble codes: 21 (Oxygen sensor shorted high).		 View
2004 Jeep Grand Cherokee 4.0L No Start, Stall
Good day and thanks for reading my post. I have this 2004 Jeep Grand Cherokee that the customer states is stalling, but would restart. He said that Sunday he drove it to work and when he go in it to leave it would crank but not start (outside temp. was 95 degr... Trouble codes: PO320 (No crank sensor signal after 3 cam signals), P1490 (low fan relay circuit open or shorted to ground), P1389 (high fan relay circuit open or shorted to ground).		 View
2005 Jeep Wrangler 2.4L Starting
Hey all you jeep guys. This Wrangler was sent to us by another shop with a no crank no start condition. Our inspection found no ground to the starter relay from the PCM. We check all the power and grounds to the PCM and all were good as was the security system...		 View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1995 Chrysler LHS 3.5L compressor
Thank you all who took the time to reply! The responses were almost all the same. Look twards the pressure transducer. I hooked up the scan tool to read the psi. One minute it would show 0 psi the next 400 psi. Occasionally it would read in the 30's. When it d...		 12
2004 Chrysler Pacifica 3.5L Lighting
thanks for replies, as mentioned-the main problem was no exterior indicators, I had said the drl goes out when activated, many posts told me this was correct, checked the powers grounds to bcm and replace bcm, it was a used car lot whom bought at auction, and...		 7
2002 Dodge Intrepid 2.7L mode door actuator
COuldn't obtain much information on this circuit, So as was suggested I took it apart. By taking the circuit board of the selector switch out I could see that only one of two connectors was for the mode & temp doors, the other connector is strictly for the fan...		 2
2002 Dodge Pickup 5.9L Misfire
Changed injection pump and installed new lift pump, thanks for all the responses. The truck runs great. Trouble codes: p1690 (Injection pump speed doesnt agree with ecm ckp speed).		 10
2003 Dodge Dakota 3.9L transfer case
an iatn member posted input which made me take a second look at my wiring.what i found was tranny had been r&r in past guess what some one forgot to unplug? encoder motor wires were pulled apart causing a short at transfer case mode sensor. note all my wirin...		 1
2007 Dodge Pickup 5.9L exterior lights
Those of you that suspected the trailer wiring were right on. After careful questioning we found that the owner was towing a trailer at the time of the accident. The wiring connector was compromised. Once repaired everything worked fine. Thanks to all. 		14
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next