|
|
1964 Ford Tbird 390CID guages
Customer has has car since new. He brought it in with top
problems that i have corrected and stated the temp guage
was not working. I checked the operation of the guaqe by
grounding and the guage operated to full hot. I replaced
the tenp switch with an OEM sen... |
View |
|
1996 Ford Pickup 4.9L No Start, Cuts out, Stall, MIL Lamp on
this truck has a intermittent stall then a no start
problem. customer brought it in a few months ago and i
drove it home a few nights with no problems. i wanted to
try something, so with another tech's input i replaced eec
& fuel pump relay, i wanted to (and d... Trouble codes: P0420 (cataylist inefficency). |
View |
|
1999 Ford Econoline 5.4L Cuts out, Stall
Customer complains of stall after start, or will quit in
intersection and then restart immediatly. States that it
took 20 tries yesterday to keep it running and get it to
our shop. Of course now at our shop I cannot duplicate the
problem. All sensors and readi... |
View |
|
2000 Ford Pickup 4.2L Hesitation
I have tried to synchronized the timing(camshaft sensor)
but I can't get a clear description of what's tdc. I have
bump started to hear the explosion on cyl#1, then manually
find the highest point of the cyl 1 piston, which
correlated to the middle point of al... |
View |
|
2000 Ford Pickup 7.3L engine
truck come in missing and smokeing ,retrieve dtc p0281
(#7cyl)on the cyl contribution test. the buzz test
good.replaced injector with no luck,preform compresson test
and found that #1 3 and 5 were about 425 to 450 lbs and #7
was at 150 lbs ouch!. now the truck... |
View |
|
2001 Ford motorhome 6.8L MIL Lamp on
hey guys, this one is for you ford guys. sorry the vin is
wrong, I didnt have it at the time of posting. This
motorhome came in a while back in fail safe with just a po
720 code. found output speed sensor wires chewed. repaired
wires and installed new connecto... Trouble codes: po722 (output speed sensor malfunction), po720 (output speed sensor signal), po503 (vss intermittent). |
View |
|
2003 Ford Ranger 4.0L MIL Lamp on
I have 2 codes in this one. Lean bank 1 lean bank 2,fuel
pressure and flow are good. No vacuum leaks found, intake
plenum gaskets have been replaced. No egr to screw up. Long
term fuel trim is 25% on both banks. At idle the short term
fuel trim runs up to 18% ... Trouble codes: p0171 (lean bank 1), p0174 (lean bank 2). |
View |
|
2004 Ford Pickup 5.4L air bag
have code 1884 for pas air bag light out, replaced switch
with used one, same problem, checked wires in back are good
check stereo has factory radio |
View |
|
2005 Ford Econoline 6.0L Hesitation, Surge, Cuts out, Stall, MIL Lamp on
cust. says this thing will start and die numerous times
when cold (eot under 100 deg). hookup laptop/ids has cam &
crank sensor codes. clear codes. monitor icp,ipr,vref,
vpwr,all app's,all ficm powers, maf, load, sync & ficm
sync. what happens is the engine wi... Trouble codes: p0336 (ckp sensor a ckt. rangeperformance), p0341 (cmp sensor a ckt. rangeperformance), p2614 (cmp output ckt open), p2617 (ckp output ckt open). |
View |
|
2000 Lincoln Town Car 4.6L radio back light
this lincoln has no back light power to radio buttons. all
other illumination ok-door handles, inst. cluster, hvac
control panel, ash tray & p/mirror back light. heres the
story. mod & all data show back lght power on circuit
484-orange/black wire going to pin... |
View |
|
2000 Mercury Villager 3.3L MIL Lamp on
vehicle came in with the check engine light on and no
drivablity concerns.hooked up modis and no codes on either
side of pcm.both times the scanner was hooked up the light
would disappear and the drive monitors would reset.i drove
the drive cycle all moitors w... |
View |
|
2005 Mercury Mariner 3.0L No Start, Stall, NO CRANK
someone please help. this merc is driving me nuts. it is
somewhat intermittant on starting and cranking. suv was
towed in with a no crank, tested starter, fuses, relays.
all checked good. next tried to hook up scanner with no
luck will not communicate with any... |
View |
|
1964 Ford Cobra replic 460CID Poor Fuel Economy,
My many thanks to all that responded!
I have decided to set up both carbs different and make the driver pull a plug after the first day! 5000 feet of altitude
is a big change for a carb. And it is something we take for granted in this age of fuel injection!Th... |
8 |
|
1997 Ford Pickup 7.3L No Start, MIL Lamp on
We got some really great replies on this problem. All of you guys really know your stuff.We performed the injector buzz test that Chris from California told us to do. It gave us a good starting point as injectors did not buzz. James from Ohio sent us an awesom... Trouble codes: P1663 (FDCS Circuit Fault), P0470 (Exhaust pressure sensor fault), P1705 (Not in P or N during KOEOKOER). |
13 |
|
1999 Ford Contour 2.0L engine\pcv
Thanks to tom for the help. At idle there was a small amount of oil mist coming from the breather tube due to blowby. I poured some seafoam down the cylinders and let sit overnight. After clearing it all out the blowby was greatly reduced. I am pretty sure th... |
1 |
|
2003 Ford Pickup 6.0L No Start, MIL Lamp on
Customer took the truck to the dealer. dealer says it was a bad fuel pump. some diode goes out in the pump and will cause the check engine light code. The pcm monitors power to the pump so I thought maybe it was a relay. I wonder if the pcm monitors the ampera... Trouble codes: P0232 (fuel pump circuit in active), P0266 (cylinder inbalance cylinder 2). |
5 |
|
2003 Ford Focus 2.0L Poor Idle Quality, Hesitation, MIL Lamp on, engine performance
Once again I would like to thank everybody that offered help. IATN is allways ready to lend a hand. This posting was for a friend that has limited resources but I am glad to say that we hadthe tech check the valve clearances and they were not spec. seeing how... Trouble codes: P0750 (Shift Solenoid A Circuit Failure). |
8 |
|
1999 Mercury Villager 3.3L No Start
This van had a used ECM setting on the floor but I was not sure if it was correct . The ECM that was in it had just been rebuilt . I was pretty sure I had a ECM problem so I stuck the used one in and have put 100 miles on the van my self with no more problems ... |
3 |
|
2000 Mercury Mountaineer 5.0L Misfire, MIL Lamp on
REMOVED ONE AND FOUR INJECTORS FROM FUEL RAIL AND FOUND THAT IT WAS NOT INJECTING A STEADY STREAM OF FUEL TO ONE AND FOUR CYL'S. FOUND THIS OUT BY PUTTING A SMALL AMOUNT OF BRAKE CLEANER IN THE TOP OF THE INJECTOR AND POWERING IT UP WITH A LEAK DOWN TESTER T... Trouble codes: P0304 (missfire cylinder 4), PO301 (missfire [...]). |
3 |
|
Prev
