|
1992 Honda Accord 2.2L Hesitation, Misfire
ok techs i need help car came to us running poor hot or
cold and a miss in #1 cylinder changed plugs all where fuel
fouled pulled injector on # 1 looks good pull the injector
harness plug no change in running condition.swapped with
another injector problem not... |
View |
|
1992 Honda Accord 2.2L sluggish no power
Car has very slow pick-up on acceleration, from a stop
while accelerating, gradually speeds up to speed very, very
slowly as if the CAT was plugged up; if I manually shift to
2nd, it will speed up suddenly at a normal speed. Inspected
shift solenoid, working n... |
View |
|
2001 Hyundai XG300 3.0L air bags
vehicle never in collision scan data shows air bag light
off but the instument panel light is on. thanks in advance |
View |
|
2002 Isuzu Axiom 3.5L driveline
when stopping,right at last bit of rolling,like when
stopping at traffic light,the rear diff.sounds like it is
rolling up,then it relaxes?like it is lose in its
mounts,also when you accelerate it sounds like it rolls the
other direction,could it be rear brakes... |
View |
|
1993 Lexus LS 400 4.0L 30 amp am2 fuse
Turn key to the start posistion the am2 30 amp fuse pops.
The 7.5 amp fuse after the ignition switch feeding the
neutral safety start does not pop so it is good. The am2
fuse feeds the ignition switch and no obvious shorts have
been found. Any help would be gr... |
View |
|
1990 Mazda MX-5 Miata 1.6L No Start
Intermittently this will not start and has no spark. Next
time it may or may not. It seems like if you dont turn the
key back when it wont start it continues no not start. When
you turn the key back it usually then starts. This only
does not start maybe on in ... |
View |
|
1999 Mitsubishi Eclipse 2.0L MIL Lamp on
I'm looking for info on the Evap purge solenoid wiring
diagrams on mitchell it show that both wires come from the
pcm to the purge solenoid. On one side i have B+ on the
black/white wire at the solenoid but have nothing at pin 70
at the PCM. On the other wire ... Trouble codes: P0443 (evap purge solenoid control circuit). |
View |
|
1994 Nissan Pickup 3.0L No Start
For all the Nissan guys. This is my personal work truck.
The waterpump sezied on me and with some time I was able to
get it out with the removal of the timing belt(even though
alldata said you didnt have to). I was unable to get the
crank pulley off so I just ... |
View |
|
2003 Nissan Sentra 1.8L oil
This car had PO420 stored for a catalyst inefficiency. This
car is burning oil pretty bad. All cylinders are low on
compression. I remember reading about a Nissan tech
bulletin for the cat coming apart and scoring the cylinder
walls? I can't find it on ALLDATA... |
View |
|
2004 Nissan Altima 2.5L right front headlight
This altima came in for a low beam headlight replacement.
The ground terminal was melted. The terminal end was
replaced and when you connect it it immediately starts to
heat up? to the point of melting the wire. The fuses never
blow but it will get hot enough ... |
View |
|
1989 Toyota Pickup 3.0L Starting
This vehicle came to us as a no start. We checked it out
and found out that we have fire, fuel pressure, but no
injection pulse. We had a rebuilt distributor here. so we
plugged it in and spun it by hand. The coil fired and the
injector pulsed, so we installed... |
View |
|
1996 Toyota Cavalier 2.4L theft lock
I can not scan this vehicle- Car wont start. I belive to be
in theft lock mode. We have spark and fuel pressure. Car
start if keep cranking or on first crank. Any body can shed
any light on this will be great. |
View |
|
2001 Toyota Sienna 3.0L MIL Lamp on
Customer came in with the Check Engine Light On. I hooked
up the Snap-on scanner and found only 1 code po136. I
replaced both 02 sensors and clear the Light. The customer
came back the next day the Check Engine On again. I check
with scan again found the same ... Trouble codes: po136 (Bank 1 O2 Sensor). |
View |
Prev
