Prev iATN Members TechHelp for June 13, 2008
Automotive Technical Exchange for the Automotive Repair Professional
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1999 Chrysler Sebring 2.5L No Start
This car was towed into us. The customer states that while she was sitting in the drive thru at a McDonalds, The engine stalled. It restarted and she drove a few feet and it died again. This time it would not crank over. When we got the car we noticed the (no ...
View
2002 Chrysler PT Cruiser 2.4L hazard lights
Good morning gentlemen, I have a pt cruiser when the the hazard switch on top of the multi function is pushed in, the flasher which is pluged into the multi function switch buzzes,the contacts fuse togther and then pops the fuse.If we dont touch the hazard swi...
View
1999 Dodge Durango 5.9L Poor Idle Quality, Hesitation, Stall, Poor Fuel Economy, MIL Lamp on
hey guys, hope there is a chysler tech out there.. i am working on a 99 dodge durango with a 5.9 gas engine with a idle issue. during idle upon cold or hot start the iac valve seams to be opening full and causes the car to run rough,rich and stall. you could h...
View
2000 Dodge Neon 2.0L MIL Lamp on
vehicle came in from another shop, cylinders had been washed out so a used engine had been istalled by us.road test was good. car came back, p0420 catalyst efficiency failure. replaced cat with factory cat.replaced both oxygen sensors. same code came back, not... Trouble codes: p0420 (L bank catalyst efficiency failure).
View
2001 Dodge Intrepid 2.7L Cooling Systems
This vehicle belongs to a local dealer, has a 2.7L V-6 runs good and was cooling fine. All of a sudden the system started overheating. We inspected the vehicle and found the cooling fans operating. A broken recovery tank was replaced. The radiator seemed to be...
View
2003 Dodge Pickup 5.9L No Start
cummins diesel fans. need some help. have a customer with a no start when the engine is warm. we preformed a fuel injection flush on this vehicle with no help. he has already taken it to a diesel shop and they recommended he replace all injectors. strange, thi...
View
2003 Dodge Pickup 5.9L speedo
Thanks for any help guys and gals, When sitting in Park, reverse and neutral, the speedo needle bounce from zero all the way to 120mph and it actually adds miles on to the odometer, disconnected VSS, no change, when driving down the road, it is less frequent b...
View
2003 Dodge Stratus 2.7L engine
This car was driving at highway speed and the oil filter gasket blew out. The oil light did not come on and the lifters did not click. The car stopped and the engine would not turn over after that. We installed a used engine with 55 thousand miles on it. Trans...
View
1993 Eagle Talon 2.0L engine
Hello, I could use some ideas on this eagle talon. It origanly came in w/ a blown head gasket and bent valves. We pulled the engine and did a comeplete rebuild. New pistons and valves. Also installed new turbo. Started smoking right away mostly white/blue smok...
View
2000 Jeep Cherokee 4.0L Poor Idle Quality, Misfire, MIL Lamp on
Hey guys, need help on this one. Cylinders #3 and #4 are dead, the signal from the PCM is very weak. We ran a seperate wire from the PCM to the coil to eliminate shorts or poor connections. The cam sensor reading is good and the crank sensor appears to not hav... Trouble codes: PO353 (Ignition primary fault- cylinder 3).
View
2002 Jeep Liberty 3.7L engine light
I need help fellas. I had this jeep come in with these codes and found no information in alldata for either. p1899 is in ecm and p0705 in tcm. using a wiring diagram and good old fashion know how I ohm tested all the wires and found no issues. I have replaced ...
View
2003 Jeep Liberty 3.7L No Start
customer came in check engine light on and stall sometime found code 320 check scanner sometime no crank signal replace crank sensor it run perfectly fine for 3hrs pull the car ready to call customer pick up it die and never start again got cam and crank signa... Trouble codes: 320.
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1995 Chrysler LHS 3.5L No Start, floods
ok thanks to all for the help. unfortunatly, even though the car is fixed i still didnt trust it until the customer came in with coffees this morning. all i did was change the plugs again and put another new crank sensor in form the dealer, and it fired right ...
11
2001 Chrysler Town & Country 3.8L tcc
I had 11 replies to my problem. Almost every one was right. After all of the time and money wasted I tried yet another torque converter. Has worked perfectly for 2 days now, I'm sure it is fixed. This is the first time I have used the help requests and ...
11
2005 Chrysler PT Cruiser 2.4L No Start
car is running fine now. sync or no sync . problem turned out the green/orange feed wire to coil and injectors had voltage but could not carry amps. connector c103 under intake had a small burnt spot in the terminal for this wire cleaned and tightened terminal...
4
2000 Dodge Durango 4.7L Excessive Emissions, MIL Lamp on
Thanks to all that took time to respond to my help request. A special thanks to Mike in Michigan,Rick in Montana,and Thomas in New York they had been there done that. Upon a closer inspection of the oxygen sensor there was a small amount of fluid. I then check... Trouble codes: PO171 (system lean).
8
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next