|
|
1998 Audi A4 2.8L MIL Lamp on
i need help with this one. this audi has these codes which
all data says are just about all short to ground issues. i
tested all ground and did not find any problems. however i
do not get proper voltage supply to my o2 sensors all of
them. also when i run the ... Trouble codes: 17843 (17829-), 17829 (17833-), 17833 (17923-), 17923 (17880-), 17880. |
View |
|
2002 Audi A4 3.0L MIL Lamp on
Thanks for your time to try to help me. I believe this car
needs the updated CTS sensor. My question is do you have to
remove the intake manifold to replace it and if so what are
the steps to remove the manifold. Any tips to make the job
easier? I never remove... Trouble codes: 16502 (Coolant temp Signal High), P0118 (Intermittent). |
View |
|
2003 Audi A4 1.8L Front left
Audi techs,
Drivers window in in-op. Tested the switch. Test was done,
controller 46, central conv., 08 group 11. Switch responds
as it should OK. Replace the drivers side control
module-motor. still in-op. Test power and ground, OK. All
of the other windows ... |
View |
|
2003 BMW Z4 2.5L Retraction
I got this one from the dealer where they quoted my new
customer an entire top replacement $astronomical. I can
generally find the individual fault but this one has got me
stumped. The convertible top control module had two codes
retrieved by my x431. 12: Cont... |
View |
|
2000 Jaguar XJ8 4.0L Torque converter
Car came in with a knocking noise when the engine is about
2500 RPM, and the tranny is in park. Put it in drive with
my foot on the brake (putting a load on the drive train)
and the noise is gone. Removed the bolts that attach the
converter to the flywheel (so... |
View |
|
1992 Mercedes-Benz 400SE 4.2L Hesitation, Misfire
Greetings IATN members. This is our first post so please be
a little forgiving for our lack of posted information. This
400 SE came in with needing the engine harness replaced.
This harness leads to fuel injectors, cam adusting
solenoids, coolant temp sensor, ... Trouble codes: 19 (injiectors lhi sfi), 07 (ignition system di 1). |
View |
|
2000 Mercedes-Benz C230 2.3L MIL Lamp on
when under load engine rpm goes about 5000 trans does not
shift (this wot) until I reales the throttle, seems like
when the cat is plugged up, if u drive it normal is not as
bad. I have modis scanner and monitoring misfire data all
cylinders are mising just fe... Trouble codes: P0243 (af switch over actuator f compressor m166), P0170 (self adaptation at limit). |
View |
|
1993 Saab 900 2.0L Radio
I tried 4 times to re-set the radio code. I used the info I
could find in the archives with no positive results. The
power comes on and "code" lights up, but there is no sound
or change.
I replaced the radio thinking that it was an internal
problem with the ... |
View |
|
1999 Volkswagen New Beetle 2.0L Cooling Systems
Help all V.W. Techs!! This car will only overheat if it
idles more than an hour( dont ask me why the customer does
it!!).It has had O.E. water pump and thermostat installed
at a quality used car dealer by qualified Techs prior being
sent to me for a second opi... |
View |
|
2002 Volkswagen Jetta 1.8L Radio
Cust will drive car for 20 minutes w/A.M.or F.M. and radio
will go to static,cannot tune radio to any station.Shut off
radio for 5-10 minutes and turn on will work fine for
another 20 minutes,Antenna seems good radio never looses
presets no lights flashing,Not... |
View |
|
2002 Volkswagen Jetta 1.8L Stall
hello techs, this VW has us scratching our heads a little.
customer stated that the car stalls when ambient temp is
high, after stalling the EPC light is illuminated. we
scanned for codes and found those 5. the j271 relay
described in the code supplies power t... Trouble codes: p0300 (random misfire), p0301 (misfire cyl 1), p0303 (misfire cyl 3), p0562 (power supply voltage too low), p0688 (main relay j271 open circuit). |
View |
|
1998 Volvo C70 2.4L cam timing
first of all thank you guys for your help, i always succeed
and posting the help request.have a volvo s70 that came in
to our shop running with bad timing belt idler pulley.we
drove the car into the bay and it was making noise so we
shut it off and replaced th... |
View |
|
1999 Audi A4 2.8L Excessive Emissions, No Start, Poor Idle Quality, Hesitation, Surge, Poor Fuel Economy, MIL Lamp on
I thank all involved. As far as the no start, this problem was from faulty ect sensor. I let customer take vehicle and recieved cal that all is well with no start. All other codes I do suspect may be linked to bad ground or other wiring issue. Trouble codes: p0113 (intake air temp. sensor- signal too high), p0103 (mass air flow sensor- signal too high- intermitent), p0118 (eng. coolant temp. sensor- signal too high), p1141 (load calculation cross check implausible value), p1129 (fuel trim b2 system too rich), p1127 (fuel trim [...] too rich). |
8 |
|
1988 Jaguar XJ6 3.6L No Start
Thanks to all who replied. There was some conflict on just how much voltage the crank sensor should have while cranking. As stated I had about .9 volts and a clean pattern. Since I had no injector pulse AND no spark I pulled the trigger and replaced the ECU. E... |
6 |
|
1999 Jaguar XJ8 4.0L MIL Lamp on
Hi - I am being asked to close this post. We replaced the throttle body assembly last week, drove the car for two days = ok. Returned car to owner, they are driving almost daily with no problems so far. Will not really know if we are ok for a few more weeks. I... Trouble codes: P1111 (systems check complete). |
5 |
|
2000 Jaguar XK8 4.0L Steering column
Customer has rescheduled 3 times for further diagnosis, still has not shown up. Got an idea from a long time Jag guru here in Denver. There is a actuator pin in the center of the electrical portion of the ignition swith that controls all these functions when... |
2 |
|
2004 Mercedes-Benz E320 3.2L abs pump
Some great information about tire pressure and this braking system in general. To be honest before posting this I did not realize that the brake system had to be disabled before servicing. It's fortunate that I never cracked into the system before acquiring t... |
6 |
|
2006 Mercedes-Benz SL500 5.0L A/C panel
Well, this car definitely had too much to drink; we tried but couldn't wake the dead. The control panel had to be replaced. Many thanks for the responses. |
3 |
|
1990 Volvo 740 2.3L ign timing
thanks to chuck j. for the discription of the position of flywheel (auto) with #1 cylinder at tdc. the flywheel has one spot with out windows just blanksteel. correctly mounted the blank spot (2 windows width wide) is positioned at the starter hole opening on ... |
5 |
|
Prev
