|
|
1994 Ford Pickup 5.0L MIL Lamp on
can not acsess self test on scanner koeo or koer any one
ever run into this before the check engine light does come
on when key is turned on then when engine starts lite is
back on but can not comunicate to gather any codes |
View |
|
1996 Ford Crown Victoria 4.6L Misfire, MIL Lamp on
no coil driver pulse to left hand coil cyls. #2 and #8 also
no injector driver for same Cyls. Trouble codes: po354 (no injector driver or coil driver for cyls. 2 and 8). |
View |
|
1999 Ford Contour 2.0L MIL Lamp on
This car came in with the P0190 code. Checked the Fuel rail
pressure sensor, it ohmed out as a bad part. Replaced and
about 3 miles up the road the code is back. The new sensor
test out good. Also repalced the fuel filter and fixed a
faulty VCT sensor. I am no... Trouble codes: P0190 (Fuel Pressure sensor circuit). |
View |
|
2001 Ford Pickup 4.2L Misfire,
Hey Guys, this one has me, I read every single post related
to this truck. It came in with Cyl. 1 and 5 missfire, I
verified the actual miss, we then replaced the ciol pac,
plugs and wires, and did a fuel induction service the truck
ran great no miss. It came ... Trouble codes: P0301 (p0305-), P0305. |
View |
|
2003 Ford Pickup 5.4L dash alternator
hey guys. been awhile but got a problem now. this is a 2003
f250 super duty 2 wheel drive, this is a strippo truck. a
work truck, has a/c but no cruise, no power windows or
locks, rubber floor no carpet, you get the picture. this
truck will blow fuse number 45... |
View |
|
2005 Ford Freestar 4.2L Hesitation, Surge, Stall, MIL Lamp on
vehicle came in with the following complaint: "came home
last night and the car was lurching, no check engine light
on, tach bounced and vehicle died once." started vehicle
this morning, noticed rough idle and check engine light on
solid. vehicle stalled and r... Trouble codes: p0106 (baro circuit failure), p1336 (misfire monitor hardware-cmp misaligned ckpcmp noise), p2195 (HO2S11 not switching correctly. sensor indicates lean), p2197 (HO2S21 switch sensor indicates lean). |
View |
|
2000 Mercury Grand Marquis 4.6L Surge, Cuts out, Stall, Misfire
car came in to shop for state insp, trac light on and skips
and stalls under load.can duplicate in shop . trac light
comes on right before misfire happens, no codes,temp light
comes on at times and goes back out do not have exp with
fords.not shure what to loo... |
View |
|
1988 Ford Pickup 7.3L No Start
I got plenty of help from ya'll on this one. Especially from Jeff from Conn. and Bob from Georgia! These 2 guys had very good explanations on what to look for and how to fiqure it out.Unfortunately Skippy isn't motivated enough to diagnose his own vehicle and ... |
10 |
|
1990 Ford Pickup 5.8L Hesitation, Cuts out, Stall, black smoke
Thank you for all of your repiles. It turned out to be the saftey neut. switch. all of test turned out good. |
16 |
|
1994 Ford Explorer 4.0L Poor Idle Quality, Cuts out, Misfire
Well I have finally fixed it . after doing repairs I had diconnected batt and dead head computer and drove it about 5 mile and it still had problem and no codes so one of the other techs wasn't doing anything so i told him to drive it for awhile
when he return... |
8 |
|
1999 Ford Mustang 4.6L Battery
Thanks to those who replied. Heres the Readers Digest version. The feedback problem was from pinched wires in CCRM circuits #361-pin 12[PCM power] and #238-pin 5[Fuel pump power]. I was able to isolate the short by unplugging connector #200 at the right kick p... |
4 |
|
1999 Ford Econoline 5.4L Cuts out, Stall
Every reply said to replace the IAC, so, I can take a hint. Replaced the IAC and sent it down the road. So far so good. Thanks for the help.
|
9 |
|
2004 Ford Pickup 5.4L spark plug
Thanks to all of you that took the time to help. I had a couple of great ideas.The morning after I posted my help request, I got a phone call from Mike at Lisle tool corp. Mike sent me a prototype tool that actualy pushes the porcelin down to a predetermined d... |
14 |
|
2004 Ford Expedition 5.4L Charging
You guys are awsome. you all know your chit. It has to have a quality Altenator. That turned out the battery light. Installed a motorcraft from the dealer. check replies there all great.
When I replaced the pcm, I used the ford ids system. when it told me ... |
7 |
|
1996 Mercury Mystique 2.0L No Start, MIL Lamp on
Thanks for all the help sometime you have a tech on a car , and they assure you that they have crossed all the t's and dotted all the i's... But come to find out the harness replaced at the crank sensor the wires were reversed causing the no start condition.. ... |
4 |
|
Prev
