|
|
1991 Dodge Colt Vista 2.0L 4-5 shift I replaced the clutch in this morphidite. The 5th gear
shift is electronically controlled through a shift
indicator switch, a controller, a vacuum switch, and a
vacuum dual diagram operator. The operator and its
occupying storage can are mounted to the front r... |
View |
|
1996 Dodge Grand Caravan 3.8L Electronic Just completed evaporator replacement on this vehicle due
to refrigerant leak. Now I can't get the system to operate.
I tried to initiate the calibration/cool down test
procedure but it failed, the a/c & recric buttons flash
simultaneously. I retrieved codes 1... |
View |
|
2001 Dodge Grand Caravan 3.8L Gauges, Illumination Quick question for you Chrysler Tech's. Instrument cluster
goes out on this 01 Grand Caravan intermittently, both
gauges and lighting.MIC no communication code in BCM. Can
you put a used cluster in this critter. I'm no big fan of
boneyard electrical parts but ... |
View |
|
2000 Jeep Cherokee 4.0L Poor Idle Quality, Misfire, MIL Lamp on Hey guys, need help on this one. Cylinders #3 and #4 are
dead, the signal from the PCM is very weak. We ran a
seperate wire from the PCM to the coil to eliminate shorts
or poor connections. The cam sensor reading is good and the
crank sensor appears to not hav... Trouble codes: PO353 (Ignition primary fault- cylinder 3). |
View |
|
1998 Dodge Grand Caravan 3.3L Instrument cluster Thanks To All who replyied. Was really stuck on this one, you guy's really bailed me out. Removed instrument cluster and flexed circuit board, cluster would intermittenly work. Replaced
cluster with good used one for fifty bucks, works like a champ. Thanks iat... |
12 |
|
2000 Dodge Grand Caravan 3.3L compressor Thanks for the support. It was the compressor- of course. I was in denial for a minute. I have had good luck with OE oils and noise. This ended as is started, just a caravan. This customer is very picky but everyone finished happy with the truck gone and bill... |
7 |
|
1993 Eagle Summit Wagon 2.4L Excessive Emissions, Poor Idle Quality, Surge Turned out the remanufactored ecm we installed was bad,there was no voltage at pin 7 on the mass airflow sensor. So after a lot of second guessing installing a second remanufactored ecm solved the problem. |
3 |
|