|
|
1996 Ford Pickup 7.3L Poor Idle Quality, Hesitation, MIL Lamp on
Hi, folks. See above codes please. Please note the cylinder
contribution tests were taken and codes set when the
problem was occuring, which is intermittant. When it runs
fine, cyl contribution tests pass. I started by looking @
the tan and red wire that the I... Trouble codes: P0236 (MAP sensor circuit performance), P0279 (Inj 7 circ low), P0263 (1 contribution problem), P0269 (3 contribution problem), P0275 (5 contribution problem), P0281 (7 contribution problem). |
View |
|
2001 Ford Excursion 6.8L Hydroboost booster
I am converting this truck from vacuum to the hydroboost
system. I purchased all the parts new from the dealer to
find out there is a reducer fitting for the high pressure
line. I have been to 5 dealers in the area and they can not
even find a picture of it. I... |
View |
|
2002 Ford Explorer 4.0L tailgate door lock
Hello Ford techs! This is a good one. This truck came to
the shop with a complain of battery discharge (slow), the
truck would not start if let sit for 5 or more days.Ford
dealer changed alternator and battery and sent her on her
way and told the owner that ev... |
View |
|
2002 Ford Pickup 7.3L Misfire, MIL Lamp on
Dear fellowtechs; To all the 7.3 Powerstroke experts out
there. This Powerjoke came to me with the complaint that it
has to be plugged in to start and run good, even with 70
degree nights. It was just as the owner descibed; hard
start with severe misfire, gett... Trouble codes: P0773 (gear ratio 3 incorrect), P1670 (EF feedback not detected), P1247 (turbo boost pressure low), P0476 (exhaust backpressure sensor voltage), P0284 (cylinder 8 balance), P0269 (cyl 3 balance). |
View |
|
2004 Ford Focus 2.3L shuts off AC Compressor
Drove w/scanner; CHT went to 346` temp indicator moves up &
down in increments quickly revving or not, replace CHT a
month ago, seemed to solved the problem, however at the
time we had a hot spell, then a cool off when CHT was
replaced and it ran cool/normal. ... |
View |
|
2004 Ford Pickup 6.8L Poor Idle Quality, Hesitation, Surge, Cuts out, Misfire
Hey guys. Here's the situation. I work in a governmetn
fleet, and have a troublesmoe Ford Super Duty pick up.
Complaint
Vehicle hesitates/cuts out under load (long incline) at
around 55-60mph @3000RPM in 3Rd Gear. VSS reads fluctuating
vehicle speed at idle,... Trouble codes: p0502 (VSS signal unstable). |
View |
|
2004 Ford Pickup 6.0L fuel gauge
The fuel tank goes empty when the gauge shows 1/4 tank.
sending unit has .9 volts with tank 1/4 full, open circuit
voltage of 11.6 at all times(key on or off)All data
mentioned "slosh module" with no discription of location or
operation. we used a variable res... |
View |
|
2004 Ford Mustang 3.8L cooling fan,odometer,pcm communacation
Calling all ford mustang experts i need your help with this
one.The car came in with the odometer reading dashes so i
check all the fuses. Found none blown tryed to scan the pcm
no commun.But when i scan the GEM it works fine, no codes.
While i had this car in... |
View |
|
2005 Ford Pickup 5.4L Steering
OK, this truck has a subtle but very noticable
knocking/slight shudder when turning a corner ( like at a
stop sign) the problem has been there prior to the ball
joint problem. The vehicle has to be under power, do not
feel anything when coasting, mild corners ... |
View |
|
2006 Ford Pickup 6.0L Keyless Entry Code
Hi, Customer does not have the keyless entry code for the
keypad on the door. On some older ones I was able to find a
sticker on the drivers door module that had the code on it.
Does anyone know where/if this sticker exists for this
model? I don't have easy ac... |
View |
|
2000 Lincoln Continental 4.6L Cuts out, MIL Lamp on
car came in with no fuel presser but run ok for me.changed
fuel pump,reg,filter and driver still intermittently no
fuel presser. |
View |
|
1991 Ford Taurus 3.0L Condensor
As suspected the Chinese Condenser was the problem. The condenser I got was made by Visteon and made in Mexico. Was not painted and weight 3 time less than the Chinese one. I also got rid of the Chinese Accumulater Assebly. I should have saw something was ... |
23 |
|
1995 Ford Escort 1.9L Stall
Thanks for all your helpful suggestions. Rob from British Columbia nailed it. The PCV hose was restricted, almost plugged shut and had a crack in it. We had sprayed this hose several times with choke cleaner but it did not pick the engine up. My tech squeezed ... |
8 |
|
1996 Ford Explorer 4.0L Cuts out
Had a lot of good suggestions on this one. Topping the list is a 5 volt sensor shorting out - dpfe would be the prime candidate. also possible loss of ground or power to pcm.
Unfortunately customer took vehicle during the time I posted the help, and has not ... |
9 |
|
1999 Ford Pickup 7.3L Misfire
SORRY I DID NOT GIVE ALL OF OUR TEST RESULTS YESTERDAY BUT WE HAVE TESTED WIRING AT THE VALVE COVER ALL THE WAY BACK TO THE IDM. FOUND .02 TO .04 OHMS OF RESISTANCE WE ALSO TOOK COMPRESSION ON ALL OF BANK 2 #2 350PSI #4 360PSI #6 350PSI #8 325PSI WE PERFORMED ... Trouble codes: P0284 (cylinder 8 contribution). |
10 |
|
2001 Ford Windstar 3.8L Cruise control
Thanks for the replied, I order a used cruise control servo, plug it in and go for the road test, it works. I try it for couple times it pulls every time i hit the set button. I know the servo very seldom to go but I guess I 'm the lucky one. Thanks again for ... |
2 |
|
1999 Mercury Sable 3.0L front end
Sorry I took so long. The customer took the car and re-scheduled for the right side front bearing replacement that I did today. The howling is gone! I did order a set of chassis ears to hopefully avoid this mistake again. I was sure the noise was coming fr... |
13 |
|
Prev
