|
|
1996 Ford F-Super Duty 7.3L Cuts out, Stall
vehicle came in on hook customer said vehicle misfired and
no power then stalled checked filter customer changed a few
days ago check with scan tool came up cam sensor and back
pressure sensor.installed new cam sensor removed back
pressure sensor and cleaned a... |
View |
|
2000 Ford Pickup 7.3L Mechanical
Thanks in advance for the help. Truck came in 3 months ago
for a brake pull. Brakes were not that old and rotors were
ok. I replaced with loaded calipers and test drove and pull
was gone. Fast forward to today and truck came in with left
pull and runout shudde... |
View |
|
2001 Ford Taurus 3.0L Misfire, MIL Lamp on
good afternoon,
i have a 201 taurus here, that came from the local dealer
with the check engine light on. the dealer had replaced the
cam syncro and sensor due to a check engine light, i am
unsure what code was in it at that time. the customer
brought it to u... Trouble codes: PO1309 (nisfire monitor disabled). |
View |
|
2003 Ford Expedition 4.6L Mechanical
This may sound very elementary to all of you but here
goes...We have serviced this vehicle from day one and
untill this problem started have had no previous brake
complaints to deal with. Last month we replaced the left
caliper and brake hose due to a stuck pi... |
View |
|
2005 Ford Pickup 5.4L Hesitation, Misfire
need a little help on this one.
truck came in with the complaint of no power,misfiring,mil
light flashing,pinging.the only time this problem occurs is
when you are going up hill.the problem only occurs once in
awhile,but when it happens the truck will start p... Trouble codes: PO301 (cyl 1 misfire only pending then clears itself), PO305 (cyl 5 misfire same as the po301). |
View |
|
2005 Ford Five Hundred 3.0L instrument cluster
Hello, customer stopped in today with complaint of the
instrument cluster will go dead at will. all guages become
inop and then will come back to life. radio and air
conditioning continue to operate when this happens. It is
intermittant but becoming more regul... |
View |
|
1994 Ford Taurus 3.2L compressor
I had found that there were alot of voltage drops across the circut. Thanks to the many replys I added a relay into the circut to power the compressor clucth. And thanks to Tom from Colorado. |
14 |
|
1994 Ford Mustang 3.8L Excessive Emissions
I found after reconcidering all the data that the real problem was the cats.We recomended that the customer replace the cat converters and the customer declined the repair. I did correct the original problem (leaking injector)but missed the cat problem on init... |
4 |
|
1994 Ford Ranger 2.3L Hesitation, Stall
The fix for this vehicle was rather easy but overlooked. The coolant temp sensor was reporting @104 degrees wich was colder than normal temp. This was due to a plugged heater core. The ECT sensor is mounted in the return heater hose and was not reaching ope... |
14 |
|
1999 Ford F450 Super Duty 6.8L runs hot
THANK YOU FOR ALL YA'LLS INPUT. ALMOST EVERYONE WAS RIGHT WHEN THEY SAID TO CHECK FLOW OUT OF THE RADIATOR. RADIATOR WAS 50% PLUGGED IN THE CENTER OF THE CORE. THE TANKS AND SIDES OF THE RADIATOR WERE HOT, BUT THE CENTER WAS 90 DEGREES COOLER. INSTALLED A NEW ... |
13 |
|
2003 Ford Econoline 7.3L No Start, Poor Idle Quality, Hesitation, Stall, Misfire, MIL Lamp on
Ok after the vehicle has been back on the road for 2k miles I can safely say that I had a defective IDM. I had previously installed the clips for the harness and I also went over the entire harness looking for signs of exposed wire. I also checked resistance a... Trouble codes: P1316 (idm fault codes detected), P1292 (high side 2 left short to grd. or b), P1293 (high side open right group). |
3 |
|
2004 Ford Explorer 4.6L Poor Idle Quality, MIL Lamp on, synch cam/crank
THANK YOU ALL FOR HELPING
THE CUSTOMER HAS DECIDED TO TRADE IT. SO I GUESS SOMEONE ELSE WILL GET THE SATIFACTION OF FIGURING IT OUT. ONE THING THAT I FOUND, WAS IF YOU DISCONNECTED THE CMP THE MIL TURNED OFF.
AND THE PCM WENT IN TO BACH FIRING THE INJECTORS.
... Trouble codes: po340 (cam sensor position malfunction bank1), p1336 (pcm recieves erratic cam or crank signals). |
5 |
|
2005 Ford Pickup 5.4L Poor Idle Quality, Misfire
Ok, got this one in the bag. I figured that there was a timing/valve problem because of vacuum, and almost everyone else thought the same thing. I bought the adapter for a compression test, and found that number 4 cylinder had zero compression. Leak down ch... Trouble codes: 0303 (missfire cyl 3), 0304 (missfire cyl 4), 0307 (missfire cyl 7), 0308 (missfire cyl 8), 0171 (bank one too lean), 0174 (bank two too lean). |
18 |
|
2000 Mercury Grand Marquis 4.6L Surge, Cuts out, Stall, Misfire
THANKS FOR ALL THE HELP MOST SAID THE COILS ARE WHAT I SHOULD SRART WITH ALSO TO CHECK THE ALT FOR STRAY VOLTAGE. CUSTOMER HAS NOT GIVEN ME PERMISSION TO CONTINUE BUT I DID FIND MISFIRE ON #6 and #4 with scan tool. replaced the coils on those cylinders and all... |
8 |
|
Prev
