|
1996 Ford Windstar 3.8L ABS and service brakes. This van will activate the ABS motor under normal braking
conditions.(dry pavement). Have any of you had this before?
There is a service bulletin for ABS activation when coming
to a stop or while turning, but I'm not sure what the
problem was they were having ... |
View |
|
1997 Ford Explorer 4.0L Poor Idle Quality, Misfire Hello FORD techs:
This explorer came in with check engine light on and the
code 301 and 304 stored. This truck will misfire badly only
when cold or warming up. Once it gets hot it will not
misfire anymore. I went after the lower intake o-rings. I
sprayed carb... Trouble codes: p0301 (misfire cyl 1), p0304 (misfire cyl 4). |
View |
|
2003 Ford Explorer 4.0L gear engagement This jeep came to my shop with out transmission
thecustomer say the tran was slipping. we got a
transmission from salvage jeep (know as working before
wrack) put tran in jeep fill it up and now we have a no
engagement in no gear check pressure good and no code... |
View |
|
2005 Ford Crown Victoria 4.6L Air bag system I am having a problem with the air bag system on this
vehicle. It keeps storing a B2295 and B2296 on initial
startup. This particular vehicle does not have side inpact
air bags or side inpact sensors. The seat resistors are in
place, and there are no side impa... |
View |
|
1991 Mercury Capri 1.6L No Start This car stalled on the freeway and now has no spark. The
cam signal is good and is getting to the computer. I have
12V while cranking on all three ignition module wires. I am
not getting a signal on the HAAC lt grn-yel wire from the
computer. I see no signs o... |
View |
|
1992 Mercury Grand Marquis 4.6L MLP Sensor This vehicle came to me from trans shop. The car had trans
complete rebuild, trans shop states when put into drive it
will start out in high gear or lockup & stall but reverse
is good. Found MLP sensor wired wrong according to
replacement procedure from ford. ... |
View |
|
2001 Mercury Mountaineer 5.0L Surge, Misfire, MIL Lamp on Thank you all for your time and response on this matter. I
have this vehicle that feels like it is missing and with
the code P0340. I did reset the light and see if the light
will come back on.. after I rev the engine a few time..
sure enough the code pop back... Trouble codes: p0340 (Camshaft position sensor circut). |
View |