|
|
2003 Buick Rendezvous 3.4L lr speed signal
Code C0046 for Left rear speed signal performance. Sensor
resistance in spec. @ 1125 ohlms. Spining the wheel the
sensor creats over 100 mv. checked the jumper harness from
sensor to under body all ok. check resistance from there to
the pass through connector ... |
View |
|
2001 Cadillac Catera 3.0L radio,fuel door,trunk
Customer came in today stating that, his wife was driving
there car today and it just shut off on her. The car
started back up and they continued driving. A little later
they noticed that the radio wasn't working along with the
fuel door and the electronic tru... |
View |
|
1997 Chevrolet Pickup 5.0L 2-3,3-4 shift
After o/h, no 2-3 or 3-4 shift. Modus and Tran x show
proper commands to trans. Could not achieve 3rd or 4th with
Modus or Tran x. Unplug case connector and unit is in 3rd
gear (failsafe).Installed reman valve body with no effect.
So at this point I know 1st a... |
View |
|
1998 Chevrolet S10 Pickup 2.2L no odometer
originally i had [...] on odometer and a complaint of
the odometer flickering on and off and reading 0
all other gauges work correctly and no codes present (that
i can access through my solus)
I swapped the cluster out with 2 known good clusters both
wer... |
View |
|
2001 Chevrolet Cavalier 2.2L No Start
Has anyone ran into this problem before?? Please let me
know what to do, I ahve run out of options at this point.
Thanks in Advance for all your guys help. If you guys have
any Ford, Volvo, Saab, questions just ask. I'm a Ford
Specialist, and my other partner ... |
View |
|
2005 Chevrolet Equinox 3.4L steering
hellow to all. our equinox makes a knocking noise from
under the dash when driving on rough roads. we first
thought it was the steering shaft but after replacing the
shaft the noise was still there. this does have the
electric power steering unit under the das... |
View |
|
2000 GMC Safari 4.3L Poor Idle Quality, Hesitation
this truck came to the shop with a hesitation problem when
idling or at a stop. We found out that whenever we
disconnect the purge solenoid, the engine runs normal. So i
disconnected the purge line to the purge solenoid and it
has regular gas in it. So i chang... |
View |
|
1995 Oldsmobile Aurora 4.0L MIL Lamp on
hello all i have a olds aurora that has a code 85.the light
comes back as soon as i erase it.the idle drops to slow
when reved up.i installed a new idle solenoid and relearned
the idle per alldata.i would appreciate some insite on this
problem.i have a genesis... Trouble codes: 85 (idlelearn at maximum authority). |
View |
|
2002 Oldsmobile Alero 2.2L No Start
I'm not much of a GM guy, so I need some help. Car comes in
about once a month for a no start. Everytime it comes in it
starts right up. This time it didn't, but it did at the
wrong time. The security light was flashing, so I'm
thinking Security problem. I che... Trouble codes: B2960, B2965. |
View |
|
1997 Pontiac Bonneville 3.8L starter
Hello all, thanks in advance for the help. I have this
bonneville here that is a very intermittent no start. I do
not have power on the small wire on starter when it will
not start. Have not been able to check for power at neutral
switch yet cause it is still ... |
View |
|
1999 Pontiac Grand Prix 3.8L MIL Lamp on
Hello guys and thanks in advance for all your help! This
Pontiac continually sets a CMP performance code that can't
be fixed with known new part. I have used my vetronix 5200
to compare the CMP sensor signal all the way back to pcm. I
hooked before and after t... Trouble codes: P0341 (CMP Performance Failure). |
View |
|
2001 Saturn L100 2.2L ac system
hello guys and thanks in advance for any help you can
offer. i got this 2001 saturn l100. i recently bought this
car to fix (timing chain went and needed a head) i finished
the car and have been driving it for a couple days to iron
out the kinks. i found the a... |
View |
|
1992 Buick Skylark 3.3L starting system
THANKS TO EVERYONE WHO REPLIED. RECEIVED AN OVERWHELMING 41 REPLIES. TURNED OUT TO BE A FAULTY CRANK SENSOR. TRICKY THOUGH BECAUSE WHEN THE VEHICLE WOULD NOT START, I STILL HAD AN RPM SIGNAL. SO FAR SO GOOD... I APPRECIATE ALL YOUR RESPONSES AND HELP... |
41 |
|
1999 Buick Riviera 3.8L Stall
We found that the main wiring harness, where it goes from motor to firewall, has a bad wire in it. Every time the motor flexed, it would kill the engine. The student found it but moving the wiring harness. We could not find the bad wire, I am not sure the conn... |
10 |
|
1999 Cadillac Seville 4.6L suspension
found the bushings on the front lower control arms moving in and out alot and dry causing a squeek replaced control arms and it is fixed now |
4 |
|
1995 Chevrolet Pickup 5.7L Brakes
After alot off research. This truck was a regular pickup in the beginning. The costumer had a utiltybody put on and the springs along withsome brake work were updated to heavy duty. Sometimes you have to pry information out of people just to help them. The cal... |
35 |
|
2004 Chevrolet TrailBlazer 4.2L compressor
members want to thank everyones input,steve nailed it cleaned the throttle body real good all is good now,first time i seen this,won't forget this problem thank you so much bud |
12 |
|
1996 Geo Metro 1.3L MIL Lamp on
thanks guys, it was the pressure control solenoid on the firewall, it was open coil.
thanks
chris Trouble codes: p1410 (fuel tank pressure circuit malfunction). |
3 |
|
1997 GMC Jimmy 4.3L power windows
sorry i have to close this post without a fix,customer picked up vehicle and she said to bring it back but she said she's too busy right now,i'll try to update a post if she brings it back and i apply all the suggestions i recieved,thank you very much for all ... |
10 |
|
1998 GMC Suburban 5.7L No Start, Poor Idle Quality, Surge, Misfire, MIL Lamp on
Thanks for all the help he adjusted the CMP retard and the truck was running great we also had to change cylinder #4 and #8 fuel injectors. They were faulty and causing a misfire to happen but the truck is running great thank for all the help. |
9 |
|
2003 Pontiac Sunfire 2.2L Misfire
Well I finally got this Sunfire back today to check further.The problem turned out to be just as described in the reply I received from Alex.There was a very small rub thru on the wiring harness where it passed over the trans mount.I repaired it and re-routed ... Trouble codes: P0300 (engine misfire detected). |
13 |
|
Prev
