|
|
1989 Audi 90 2.3L No Start
we found a broken distribuitor,replaced it,also found the
intake boot cracked,replaced the boot,we found that there
is not fuel out from the fuel distribuitor to the fuel
injectors,engine runs...ok...with parts clener on hi rpms
have you have this problem befo... |
View |
|
2003 Audi A4 3.0L No Start, Stall
This car runs and starts perfect over a 24hr cycle.
Customer complaint is sometimes it will just turn over no
start or start and cut off several times. It will always
eventually start. No data is goofy, no codes. |
View |
|
1999 BMW 528i 2.8L MIL Lamp on
This car has a bunch of problems. It came in with the mil
on as well as the asc, abs,and brake lights and the speedo
does not work. The car needs an inspection and will not
pass without a speedo and with the mil on. I tried to pull
codes from the obdII connect... Trouble codes: 145 (Evap leak), 144 (Evap leak large), 130 (can signal asc 1), 214 (Vss malfunction). |
View |
|
2004 Jaguar S-Type 4.2L a/c
Customer came in stating that he was loosing coolant and
that the vent on the drivers side of the dash was blowing
hot air while the center vents were cold to cool and the
passenger outside vent was ambient temp. Replaced leaking
valve and proceeded to try and... |
View |
|
1991 Mercedes-Benz 560SEC 5.6L vent temperature
Hey guy, I need help with this one. Car came in with no AC.
Inspection shows compressor leaking like a sieve.
Overhauled AC system. Now I find I can't get vent
temperature lower then 70 degrees at idle. I raise the idle
to 1100 and temp drops to 58 degrees. Th... |
View |
|
1995 Mercedes-Benz E420 4.2L MIL Lamp on
HHT DTC 019 in diagnostic module definition: Fuel
injectors open / short circuit or emission control system
adaptation in LH-SFI control module (N3/1) at limit.
Adaptations are (almost too) perfect at 1.006 part load and
0 ms at idle, have not been reset. Lam... Trouble codes: 019 (In diagnostic module only no DTCs in LH-SFI module). |
View |
|
2002 Volkswagen Jetta 1.8L Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, Misfire, MIL Lamp on
This car first came in for a rough idle when started cold
and a check engine light on. Found 2 fault codes, one was
for engine coolant temp sensor and the other was for random
misfire. When the vehicle is started cold and put into gear
it will stumble and misf... |
View |
|
1998 Volvo S90 2.9L Poor Idle Quality, Surge, MIL Lamp on
vehicle idles rough and hunts, surges and or lopes when
sitting in gear or park. The moment you give it gas it
responds pretty good and does not miss or hesitate, let off
of throttle and it is back to hunting. Replaced intake due
to leaking vacuum, checked fue... |
View |
|
2002 Audi TT 1.8L haldex system
Hello
sorry for the late delay, but did not see customer.
i did call her, and she said that the rear diff is near perfect now. --- NEAR--- that mean that when cold, for the first 5 minutes, there is a noise. after that, all is nice. So she decide not to go fur... |
4 |
|
1990 BMW 325i 2.5L Hesitation, Cuts out, Misfire, loses spark high rpm
We found the harmintic balancer seperating from toner ring for the crack postion sensor. We believe it to be the problem be we are wanting for one. Back order part have no ETA yet. Thank for all your help.
|
8 |
|
1991 BMW 325i 2.5L ABS dash light
OK guys, there was a break in the sensor wire code 82 FR (right front) and the sensor at code 113 (LF) was not faulty ! I did look for the ABS relay but could not identify it. I did check for continuity, ohms, all was good. Then checked for ABS relay, couldn'... |
8 |
|
2003 BMW X5 4.4L battery
Thanks for all you guys that tryed to help and sorry for a delayed sumary. Unfortunatelly I could not fix completely this vehicle. I replace the lock actuator on right side (I had replaced only left side) and the battery problem went away, but unfortunatelly t... |
9 |
|
2000 Jaguar S-Type 4.0L Mechanical
Thanks for the help on this one. It turned out to be the front pump. Sent car to trans rebuilder. No more noise
Thanks Mickey |
3 |
|
1992 Mercedes-Benz 300SL 3.0L Cuts out
Because of the intermitant nature of the problem I held off with this note until the customer put enough miles on the car to be satified that it was fixed. As recomended by the majority of the respondents I replaced the crankshaft sensor. Apparently after m... Trouble codes: 15 (ignition signal). |
7 |
|
1997 Mercedes-Benz E320 3.2L MIL Lamp on
Thanks to all who responded. Most everyone who responded to this problem nailed the issue with this vehicle. The fix for this vehicle was simple. I just switched to the OEM O2 sensor. I should have never let the customer supply his own part - a "universal" 4... Trouble codes: P0130 (O2 Bank 1 Sensor 1 malfunction). |
11 |
|
2000 Mercedes-Benz S430 4.3L Stall, hard start
Yes, the crank sensor was the main cause of the intermittent stall! I have diagnosed many crank sensor issues in the past, but the scantool data I was receiving did not accurately reveal a faulty crank sensor. With the end result being the crank sensor, I ha... Trouble codes: p1570 (das to ecm interrupted). |
10 |
|
2000 Mercedes-Benz ML430 4.3L lockup
I WOULD LIKE TO SAY THAKS TO EVERYONE WHO REPLYED. THE PROBLEM WAS WHEN THE TRANS FAILD, METAL FRAGMENTS GOT STUCK INSIDE TRANS COOLER. REPLACED COLLER, PULLED VALVE BODY OUTAND CLEANED IT. THE TRUCK RAN GREAT AFTER THAT, DROVE IT FOR 2 DAYS BEFORE GIVING I... |
5 |
|
1996 Volkswagen Jetta 2.0L Poor Idle Quality
Stanley from PA nailed this one with "Battery VooDoo". Normally they preach against VooDoo in my church but once long ago I did see "Midnight in the Garden of Good & Evil" and I kind of liked the fact that Stanley got up at 6:30 in the morning to write me.
... |
5 |
|
2001 Volkswagen Passat 1.8L engine
Thanks to all who responded. Unfortunately we were not able to resolve the problem. We sent the cylinder head back to the machine shop to pressure test a second time. We double checked the deck for any warpage and /or any cracks or degraded areas. The cylin... |
21 |
|
2003 Volkswagen GTI 2.8L 1-2-4 shift
everything went real easy, thanks to everyone. Bought used tranny $1500.00. It did brake the shift fork, but really chewed up the tranny. thanks again |
5 |
|
1992 Volvo 960 2.9L head and valves
thanks to all who replied, evidently these blocks are prone to crack , we ended up getting the block welded, and reassembling it. It works fine. As far as the speedometer goes, I diagnosed it as a problem in the speedo head, and the customer declined repair. t... |
11 |
|
Prev
