|
|
2001 Audi Allroad 2.7L air suspention Hello adi techs !!!
This audi came in to the shop with the air suspension lamp
on.All four corners of vechile are bottom out. on visual
inspect i can see that the lr air strut in completely
deflatted and the other three have some air in them. the
compressor d... |
View |
|
1998 BMW 740iL 4.4L airbag I removed drivers door panel and airbag to acess latch for
outer door handle. After reassembly of door airbag light
stays on ( and will not clear even after disconnecting the
batery ). I did turn ignition on to move window position
while airbag was not connect... |
View |
|
1998 BMW 328is 2.8L gauges Hi guys with BMW experience,have this 98 328is conv/car tow
in water pump broken damage rad.replace all parts ,car
would not start due to after market alarm(customer did not
know about alarm)remove alarm car starts instrumet has no
temp ,gas,rpm,odo also get m... |
View |
|
2000 Mercedes-Benz ML430 4.3L Misfire, MIL Lamp on This car started with just a slight misfire on accel and
MIL light came on- it had 3 of the 4 codes listed above. We
cleared the codes and road tested. #6 came back, we
replaced plugs and wires on that cylinder and everything
was fine. It came back missing wor... Trouble codes: P0305 (Misfire 5), P0306 (Misfire 6), P0307 (Misfire 7), P0308 (Misfire 8). |
View |
|
1987 Saab 9000 2.0L Surge, Stall hi saab tecs
could sure use your help. this old beauty has been acting
up for a while only now it is more consistent. upon cold
startup the idle will fluctuate and then die. it takes
several key cycles to get the car to idle, and as of late,
its been really s... |
View |
|
1999 Saab 9-5 3.0L rev limits in gear Good Morning!! Thanks in advance for your help. This
vehicle if brought to approximately 4,000 RPM in any gear
or neutral will rev limit by cutting fuel. RPM appears
correct on scan tool, scan data shows correct gear
selected. Due to the lack of information in... |
View |
|
2000 Volkswagen Jetta 2.0L a/c clutch signal vw techs. this jetta came in w/ no a/c concern. check of
vehicle showed no power to comp. clutch. check of wiring
diagram showed signal comes from cooling fan module.the
power feeds on 14 pin t4 and t9 are fine. the ground on t6
is fine.all power feeds to the ... |
View |
|
2002 Volkswagen Jetta 1.8L Blue smoke I think I have a bad turbo seal but would like another
opinion. Under very hard acceleration, probably under max
boost, I haven't checked, there is a lot of blue smoke out
of the exhaust. It will actually lose power, make an odd
"cracking" noise (this is the b... |
View |
|
1994 Volvo 940 2.3L Trunk latch/lock The lock cylinder and mechanism sounds like it's working.
The key lock feels as if it's rod is still connected to the
latch.
The problem is the handle rotted out and we can not get in
to the trunk.
Does any body have a way of "breaking-in" to the trunk that
... |
View |
|
2000 BMW 328i 2.8L trans control module thanx to everyone who replied,all were good suggestions.Scott confirmed that the mdk was another term for the trottle body.i replaced it and it took care of 3 codes,then the cam sensor was replaced and all of the engine codes were taken care of.the trans compu... |
4 |
|
2002 Volkswagen Passat 2.8L Poor Idle Quality, Cuts out, MIL Lamp on, EPC Light On This vehicle was repaired with a new throttle body assembly. While several people reported these being available on the aftermarket, all of our usual sources were on a severe backorder, so we purchased one from Volkswagen (PN: 078-133-062-B).
3 of our 4... Trouble codes: 18265 (Load Signal Error Message from Engine Control), 17950 (Throttle Actuation Potentiometer RangePerformance), 18047 (Accelerator Pedal Position Sensor 12 RangePerformance), 17579 (Throttle Actuation Potentiometer Signal 2 RangePerformance). |
4 |
|
2002 Volkswagen New Beetle 2.0L No Start, run circuit issue? Thanks to all that have helped with this. The intermittent "run circuit" problem was a wire to the ignition switch had corroded. I dropped the steering column trim and looked at the electrical switch for the ignition and found the wire that was not behaving. I... |
6 |
|